Tense STC-1000 Thermostat User Guide
- June 2, 2024
- Tense
Table of Contents
STC-1000
Thermostat
Quick Start Guide
(Version 22.11.32GEN)
Haswill STC-1000 –
YouTube
STC-1000 Thermostat
STC-1000 thermostat offers two relays to wire one refrigerator and one heater; it will auto-switch between the heating and cooling mode; that’s why it was taken as “All-Purpose Temperature Controller.”
Wiring Diagram
This unit does not output AC electricity; hence you have to wire all live and null wires to each port; you may use the jumper wire conveniently.
Function Menu
| Code | Function |
|---|---|
| Temperature Setpoint | |
| Temperature Hysteresis / Difference | |
| Protection Delay Time for the Compressor | |
| Temperature Calibration |
Set the Aimed Temp Range
The aimed temperature range was defined from “ ” (if lower than this, trigger
heating) to “ ” (if higher than this, trigger cooling), hence you need to set
both “ ” and “ ”.
3.1. Configure Parameters
- Hold the key for 3s to enter the menu list; the display shows the code ;
- Press the key to see the existing value, press direction keys to change it;
- Press the key to save data.
Attention: the new data will be discarded and back to normal status if
without operation in 8 seconds.
3.2. More Tips
Under normal status
- Press the key to check the temperature setpoint ;
- Press the key to check the Hysteresis value ;
- Hold the key for 3s to power off / on;
- Hold the and keys at the same time for 5s to restore factory settings.
This is not a step-by-step user manual;
It just shows the key points.
The new user should read the Full-Content Version User Manual
https://www.thermo-hygro.com/
Haswill Electronics
STC-1000 Temperature Controller for Sale – Haswill Electronics (thermo-
hygro.com)
Copyright Haswill-Haswell All Rights Reserved
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>