Silent Call DB4-MC Wireless Doorbell Installation Guide
- June 4, 2024
- Silent Call
Table of Contents
DB4-MC Wireless Doorbell
Installation Guide
WIRELESS DOORBELL INSTALLATION
Model # DB4-MC
INSTALLATION
- Remove your Silent Call Medallion Series wireless doorbell transmitter from its packaging.
- Place the doorbell transmitter firmly against the wood frame on the outside door trim, approximately 48 inches up from the doorsill. Note that if the doorbell transmitter is mounted to a metal surface, the range will be greatly reduced.
- Using a pencil, mark each screw hole on the mounting surface. Remove the doorbell transmitter from the wood trim.
- Using a small nail or another sharp pointed object, make a starter hole for transmitter case screws (included).
- Screw transmitter to door trim making sure printing on the case is right side up.
- To test the operation of the transmitter, press the doorbell button. This will cause your Silent Call Medallion Series receiver to operate.
CHANGING BATTERY
- Remove doorbell transmitter from doorframe and slide battery cover off, exposing the battery.
- Remove the battery and install a new 23AE, 12-volt alkaline battery.
- Make sure polarity (+ & -) is correct when installing the new battery.
OPERATION
- Whenever the doorbell transmitter button is pressed, a coded wireless signal is sent to any Silent Call Medallion receiver programmed to learn the transmitter, causing it to activate.
- The transmission range using a Silent Call Medallion Series receiver is about 500 feet.
Transmitter Settings
The Silent Call Medallion system is digitally encoded. All Silent Call Medallion Series receivers are capable of receiving one million different codes and the transmitters are preset at the factory to send one of the million different codes. Please refer to your receiver manual for instruction on teaching the transmitter code to the receiver.
Technical Support
For technical support on this or any other Silent Call product, please feel free to contact us. You can reach us by phone at 800-572-5227 (voice or TTY) or by Email at support@silentcall.com
Limited Warranty
Your transmitter is warranted to be free of defects in material and workmanship for five years from the date of initial purchase. During that time, the unit will be repaired or replaced free of charge when shipped prepaid to Silent Call Communications. This warranty is void if the defect is caused by customer abuse or neglect.
5095 Williams Lake Road Waterford
MI 48329 800-572-5227 v/tty
248-673-7360 fax
Website: www.silentcall.com
Email: silentcall@silentcall.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>