DENON 595173 LED Stripe Ecolite Installation Guide
- June 2, 2024
- Denon
Table of Contents
DENON 595173 LED Stripe Ecolite
DIMENSION
SPECIFICATION
INSTALLATION
SAFE INSTALLATION
WARNING
For your protection and safety, carefully read and understand the information provided in this manual completely before attempting to assemble, install or operate this product.
- Lay out the LED strip in the desired location and ensure the area is clean and dry. Do not cut the strips as it will impair the IP rating
- Before use, please check that there is no damage to the product.
- Make sure that the strip is free from all packing before use
- Make sure that the LED strip’s voltage corresponds with that of the drive unit and ensure that the polarity is correct.
- When two or more LED strips are connected, make sure the maximum recommended length is not exceeded.
- Make sure the power is switched off during installation and that the LED strips do not overlap to avoid overheating.
- It is important that the LED luminaire’s maximum specified ambient temperature is taken into consideration to guarantee its life span, if this is exceeded, the life span can be shortened.
- Use the recommended/approved assembly fittings to ensure the lifespan of the LED strip.
- Do not try to modify the product in any kind of way.
- The LED chip should not be exposed to direct sunlight.
- Do not bend or twist the strips more than 90°.
- Do not operate while the LED-strip is coiled.
- This is an electrical product, not a toy! To avoid the risk of injury or electric shock, this product should not be played with or placed where small children can reach it.
- Do not install the fixture near flammable liquids.
- Do not turn on the product before it is completely unpacked.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>