GENIE Perfect Stop Garage Parking Aid Instruction Manual
- June 2, 2024
- GENIE
Table of Contents
GENIE Perfect Stop Garage Parking Aid
Installation Instructions
- Park vehicle in desired location within the garage.
- Suspend Perfect Stop ball with the nylon cord from the garage ceiling allowing the ball to contact vehicle windshield as shown in Figure 1.
- Mark this location on the ceiling and install eyelet #1. Temporarily secure the cord at this eyelet with the ball remaining in contact with the vehicle windshield.
- Remove the vehicle from the garage and close the garage door.
- Measure the distance from the eyelet to the ball. This is Distance
- Determine your type of garage door: Multi-Panel/Sectional or Single Panel/One Piece. For Sectional doors, use Chart 1 dimensions; for One Piece doors, use Chart 2 dimensions.
- Using your Distance “A”from step 5, determine the second eyelet position from the appropriate chart (Distance “B”).
- Measure Distance “B” in a direct line back toward the eyelet #1. Install eyelet #2 (Figure 1) in the ceiling.
- Eyelet #3 is installed on the top edge of the garage door and must be located so that the three eyelets form a straight line. (NOTE: If your door is made of fiberglass or metal, drill a 1 /16 ” pilot hole to allow installation of the eyelet #3 .)
- Detach the cord from the first eyelet and thread it through the first and second eyelets.
For Multi Panel/Sectional Doors
- Pull the cord through the third eyelet until the ball reaches eyelet #1.
- Tie off the cord and remove the excess.
For Single Panel/One Piece Doors
- Pull the cord through eyelet #3 until the top of the ball is 12″ below eyelet #1.
- Tie off the cord and remove the excess.
NOTE: All measurements above are imperial inches
For additional information or help, call Customer Service at
1-800-354-3643
The Genie Company
1 Door Drive
Mt. Hope, Ohio 44660
For patent information visit
www.geniecompany.com/patents
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>