GENIE GER-R Emergency Release Kit Instructions
- October 27, 2023
- GENIE
Table of Contents
GER-R Emergency Release Kit
Instructions
Operation Information:
The Emergency release Kit is designed to provide access to your garage from
the outside in the event of an electrical power failure and no other means of
entry is available.
The Emergency Release Kit is designed for use with standard-type garage doors
and garage door openers. If any modifications were required to your garage
door(s) or garage door opener(s) at the time of installation, the length of
cable supplied may not be adequate and additional cable will have to be
purchased locally.
Simply insert the key, turn it 1/2 turn and remove the entire inside lock
assembly. This allows access to the cable, which is connected to the carriage
release device on your door opener. A tug on the cable will disengage the
carriage release allowing manual operation of the garage door.
The cable and lock assembly may extend a foot or so when used but, this will
not affect the operation.
Replace the cable and lock assembly after disconnecting the door arm, by
pressing it into the housing and turning the key 1/2 turn to the locked
position. Reconnect the door opener carriage release device as per
manufacturer’s instructions.
Determine Door Type:
SECTIONAL DOORS
The lock assembly is generally installed in the top door section directly
beneath the door opener carriage release mechanism. It may be installed in a
vertical position on a vertical stile or, if no stile is located directly
under the door opener carriage release, it may be installed horizontally on
the bottom brace of the top section.
ONE-PIECE DOORS
The lock assembly must be instally approximately midway between the top and
bottom of the garage door and directly beneath the door opener carriage
release mechanism.
INSTALLATION
To install, drill a 3/16′ guide hole through the garage door where your plan
to position the center of the lock assembly. At this guide hole, drill a 3/4″
hole about half way through the door-follow this by drilling a 3/4″ hole from
the inside of the door to finish the hole completely through the door. (This
proceedure eliminates any chipping on wooden doors.) Insert the lock assembly
and use it as atemplate for determining the location of the mounting bolt
holes. Drill 3/16″ holes through the door at these two points. Insert bolts
and apply flat washers and nuts and tighten securely. If bolts are too long
after assembly, cut off excess and dress the threads with a file or thread
chaser. Determine the type of opener:
SCREW DRIVE
Connect the cable to the release lever (where the red release cord is
attached) on the carriage using the s-hook. CHAIN/BELT DRIVE
Connect the cable to the square spring loaded loop next to the red release
lever using the s-hook.
FOR ADDITIONAL INFORMATION OR HELP.
CALI. CUSTOMER SERVICE 1-800 354 3643
2011 by GMI Holdings, Inc
37392500131
3/242011
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>