Genie EKSC Screw Drive Rail Extension Kit Instruction Manual
- June 4, 2024
- GENIE
Table of Contents
Genie EKSC Screw Drive Rail Extension Kit
WARNING
Carefully read all instructions and warnings contained in the
Assembly/Installation poster and/or Owners Manual prior to assembly of this
kit. Safety glasses are required for this assembly. Edges of rail and
connector sections can be sharp. Avoid contact with edges.
NOTICE: These instructions supersede installation poster steps 3 & 4 (1 c
& 1 d)
Parts Included: Screw Extension (XS), Additional Rail Connector (K), Rail
Extension (X), 2-ea. Clips & Collars.
ASSEMBLE THIS KIT ON A FLAT CLEAN WORK SURFACE. (Alpha numeric digits in
parenthesis (1aJ indicate steps on older posters)
- Assemble screw rail per installation poster steps 1 through 2 (1 a/1 b).
- Pull screw drive sections out of rail sections B & C to allow assembly of extension screw. FIG. 1.
- Install screw extension (XS) between sections B & C with clips and collars included with this kit. FIG. 1.
- Install rail connector K to rail section B until it locks. Care should be taken NOT to bend screw connections. FIG. 2.
- Install rail section C into rail connector K until it locks. Care should be taken NOT to bend screw connections. FIG. 2.
- Screw drive section will now protrude beyond original rail section C. FIG. 3.
- Install rail connector XK onto rail section C until it locks. FIG. 3.
- Install rail extension X into rail connector XK until it locks.
- Continue assembling screw rail assembly per installation poster step 5 (1 e).
- Remember to complete step 6 (1 f) for screw sections A & B.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>