Russell Hobbs 25592-56 Handheld Garment Steamer Instruction Manual
- June 2, 2024
- Russell Hobbs
Table of Contents
25592-56 Handheld Garment Steamer
Instruction Manual
25592-56 Handheld Garment Steamer
Read the instructions, keep them safe, pass them on if you pass the appliance on. Remove all packaging before use.
IMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience
and knowledge if they have been supervised/instructed and understand the
hazards involved. Children shall not play with the appliance. Cleaning and
user maintenance shall not be done by children unless they are older than 8
and supervised. Use and store the appliance out of reach of children under 8
years.
Between uses, the steamer must be rested on a stable, level, heat-resistant
surface.
Don’t leave the appliance unattended while plugged in, or while it’s resting
between uses.
Unplug the appliance before filling, before cleaning, and after
use.malfunctions or leaks.
If the cable is damaged, return the appliance in order to avoid a hazard.
The surfaces of the appliance will get hot during use.
Do not immerse in any liquid.
- Never use anything except water to fill or clean the appliance.
- Never steam clothing that is being worn.
- Never aim steam directly at people, animals or plants. Steam is hot and can cause serious burns and scalds if used without care.
- Never hold the steam head downwards while at rest, or tilt it backwards as this may cause hot water to be discharged and possible injury.
- Ensure the appliance is switched off and cooled down before fitting or removing attachments.
- Don’t use the appliance for any purpose other than those described in these instructions.
HOUSEHOLD USE ONLY
PARTS
- Steam trigger lock
- Steam trigger
- Handle
- Water tank
- Power button
- Lint attachment
BEFORE USING FOR THE FIRST TIME
- Remove labels, stickers and packaging from the appliance.
- Read all instructions and warnings.
IMPORTANT INFORMATION
- For best performance, we recommend using distilled, purified or filtered water in your steamer. Tap water contains minerals that can build up inside your steamer over time and reduce its efficiency or even cause damage.
- Never use perfumes, oils or other additives.
- Always check the garment’s care label before steaming, and always test fabrics for colourfastness in an inconspicuous area. Steamers are not recommended for use on leather, suede, vinyl, plastic, or other materials that are sensitive to steam.
- During use the steamer and accessories will become HOT. Never try to fit or remove attachments while still hot.
- After preheating, prime the water pump by holding the steam trigger until steam forms.
- It is normal to feel or hear the water pump inside the device. It may become louder when the water level in the tank is low. Check and refill the tank when required.
- Small amounts of dripping might occur during use. If excessive, your steamer needs time to get back up to full temperature. Just allow the steamer a minute to reheat.
- Wearing clothes immediately after ironing or steaming can actually create wrinkles. Always allow the clothing to cool for about 5 minutes before wearing.
LINT ATTACHMENT
Use on garments labelled that allow the use of steam.
Tip: The pad on the attachment helps remove lint, hair, and animal fur.
Fitting/Removing (Fig. A)
- Make sure that the steamer and attachment are cool.
- Hook the top of the attachment over the top edge of the steamer. Click the bottom edge into place. Make sure it is fully fitted and not loose or it may detach itself during use.
- Remove the attachment using the tab. When removing the attachment, watch out for condensation that may have built up during use.
FILLING
- Place the steamer on its base on a stable surface.
- Pull out the removable water tank (Fig. B)
- Gently open the rubber cover at the top of the tank.
- Fill until the water reaches the “MAX” level mark on the side of the tank (Fig. C). Do not overfill. Close the rubber cover securely.
- Dry off any excess water from the tank then refit it into the base until it clicks.
- To refill at any time during use, turn the steamer off by pressing the power button until the blue indicator light goes out, unplug from outlet, and follow the above procedure.
- After refilling, allow to reheat for 45 seconds and then prime the pump by holding the steam trigger until steam forms.
USING
- If the label says “do not steam” or shows this icon do not steam the garment.
-
Hang the garment in an area that will not be affected or damaged by the heat and steam, such as on a shower curtain rail, or in an open doorway.
-
Fit the lint attachment if required.
-
Set the switch to the I position. The light will come on.
-
After about 45 seconds your steamer will be ready to use.
-
Prime the water pump by holding steam trigger until steam forms.
-
To generate steam, press the steam trigger. As long as the trigger is held, steam will emit from the steamer. When the trigger is released, the steam will stop.
• To generate a constant flow of steam without holding the trigger, press the steam trigger and then slide the steam trigger lock downwards. You can then release pressure on the steam trigger. To turn the steam off, press the trigger, slide the steam trigger lock upwards, then release the trigger. -
With your free hand keep the fabric taut. Steam the garment with slow, downward strokes, keeping the head of the steamer in contact with the fabric.
-
Switch the appliance off ( O ) and unplug it.
-
Stand the steamer on its base and allow it to completely cool off before storing. To avoid mineral buildup, empty the tank after each use.
CARE AND MAINTENANCE
- Make sure steamer is off, unplugged and completely cool.
- Wipe all surfaces with a clean damp cloth.
- After the steamer has been thoroughly dried, turn it back on and lightly steam over an old cloth. This will help remove any residue left in the steam holes.
- To avoid mineral buildup, empty the tank after each use.
- Wipe the lint attachment with a damp cloth to clean it.
TROUBLESHOOTING
| Problem | Possible Cause | Solution |
|---|---|---|
| Not enough steam or no steam is coming out of the steamer. | The steamer is not | |
| heated to full temperature. | Always allow steamer to preheat at least 45 |
seconds.
There is not enough water in the water tank.| Fill the water tank.
The water pump hasn’t been primed.| After preheating, always prime the water
pump by holding the steam trigger until steam forms.
Discoloured water is coming through the holes and staining the fabric.|
Residue has built up in the water tank.| Empty the water tank after each use.
Only use distilled, filtered, or purified water.
Perfumed or scented additives were used.| Never use perfumed or scented
additives.
Steamer is leaking or spitting.| Steamer is not hot enough.| Allow the steamer
to heat for about 45 seconds.
Water tank is running low.| Fill the water tank.
RECYCLING
To avoid environmental and health problems due to hazardous substances, appliances and rechargeable and non-rechargeable batteries marked with one of these symbols must not be disposed of with unsorted municipal waste. Always dispose of electrical and electronic products and, where applicable, rechargeable and non-rechargeable batteries, at an appropriate official recycling/collection point.
25592-56 220-240V~50/60Hz 1600 Watts
25592-56 220-240В~50/60Гц 1600 Вт
T22-9002394
www.russellhobbs.com
25592-56
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>