snap one WB-250I-IPW-2 Wi-Fi Surge Protector User Guide
- June 3, 2024
- Snap One
Table of Contents
snap one WB-250I-IPW-2 Wi-Fi Surge Protector
Important Safety Instructions
Read the safety instructions before using this product.
-
Read these instructions.
-
Keep these instructions.
-
Heed all warnings.
-
Follow all instructions.
-
Do not use this apparatus near water.
-
Clean only with dry cloth.
-
Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
-
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
-
Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
-
Use only with the cart, stand, tripod, bracket, attachments, accessories or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. Do not place the device in an unstable position where it might fall and cause injuries. This equipment is not suitable to use in locations where children are likely to be present.
-
Unplug this apparatus during lightning storms or when unused for long periods of time.
-
Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
-
This equipment uses AC power which can be subjected to electrical surges, typically lightning transients which are very destructive to customer terminal equipment connected to AC power sources. The warranty for this equipment does not cover damage caused by electrical surge or lightning transients. To reduce the risk of this equipment becoming damaged it is suggested that the customer consider installing a surge arrestor.
-
To completely disconnect unit power from the AC mains, remove the power cord from the appliance coupler and/or turn off the circuit breaker. To reconnect power, turn on the circuit breaker following all safety instructions and guidelines. The circuit breaker shall remain readily accessible.
-
This product relies on the installation of the building for short-circuit (overcurrent) protection. Ensure that the protective device is rated not greater than: 20A.
-
WARNING – Power Sources, Grounding, Polarization
This product requires a properly grounded outlet for safety. This plug is designed to be inserted into a NEMA 5-15 (three-prong grounded) outlet only. Do not force the plug into an outlet that is not designed to accept it. Never dismantle the plug or alter the power cord, and do not attempt to defeat the grounding feature by using a 3-to-2 prong adapter. If you have a question about grounding, consult your local power company or qualified electrician.
If a rooftop device such as a satellite dish connect to the product, ensure that the devices’ wires are also properly grounded.
The bonding point can be used to provide a common ground to other equipment. This bonding point can accommodate minimum 12 AWG wire and should be connected using the required hardware specified by the other bonding point. Please use termination for your equipment in accordance with the applicable local agency requirements. -
Notice – For indoor use only, Internal components are not sealed from the environment. The device can only be used in a fixed location such as a telecommunication center, or a dedicated computer room. When you install the device, ensure that the protective earthing connection of the socket outlet is verified by a skilled person. Suitable for installation in information technology rooms in accordance with Article 645 of the National Electrical Code and NFP 75.
-
This product can interfere with electrical equipment such as tape recorders, TV sets, radios, computers, and microwave ovens if placed in close proximity.
-
Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage points or short-out parts that could result in fire or electric shock.
-
WARNING – No user-serviceable parts inside. If the product is not operating properly, do not remove any part of the unit (cover, etc.) for repair. Unplug the unit and consult the warranty section of the owner’s manual.
The lightning flash and arrow head within the triangle is a warning sign alerting you of dangerous voltage inside the product.
Caution: To reduce the risk of electric shock, do not remove cover (or back). No user-serviceable parts inside. Refer servicing to qualified service personnel.
The exclamation point within the triangle is a warning sign alerting you of important instructions accompanying the product.
Warning!: To reduce the risk of electrical shock, do not expose this apparatus to rain or moisture.
Europe Compliance
Compliance of this equipment is confirmed by the following logo that is placed on the product ID label that is placed on the bottom of the equipment. The full text of the EU Declaration of Conformity (DoC) is available on the regulatory webpage:
United Kingdom (UK) Compliance
Compliance of this equipment is confirmed by the following logo that is placed
on the product ID label that is placed on the bottom of the equipment. The
full text of the UK Declaration of Conformity (DoC) is available on the
regulatory webpage:
Recycling
Snap One understands that a commitment to the environment is essential for a health life and sustainable growth for future generations. We are committed to supporting the environmental standards, laws, and directives that have been put in place by various communities and countries that deal with concerns for the environment. This commitment is represented by combining technological innovation with sound environmental business decisions.
WEEE Compliance
Snap One is committed to meeting all requirements of the Waste Electrical and Electronic Equipment (WEEE) directive (2012/19/EC). The WEEE directive requires the manufacturers of electrical and electronic equipment who sell in EU countries: (1) label their equipment to notify customers that it needs to be recycled, and (2) provide a way for their products to be appropriately disposed of or recycled at the end of their product lifespan. For collection or recycling of Snap One products, please contact your local Snap One representative or dealer.
Australia & New Zealand Compliance
Compliance of this equipment is confirmed by the following logo that is placed
on the product ID label that is placed on the bottom of the equipment.
About this Document
Copyright © 2022 Snap One All rights reserved.
1800 Continental Blvd. Suite 200 • Charlotte, NC 28273
866-424-4489
snapone.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>