snap one B-900-MOIP-4K-TX 900 Series 4K Media Over IP Receiver User Guide
- June 9, 2024
- Snap One
Table of Contents
snap one B-900-MOIP-4K-TX 900 Series 4K Media Over IP Receiver
Important Safety Instructions
Read the safety instructions before using this product.
- Read these instructions.
- Keep these instructions.
- Heed all warnings.
- Follow all instructions.
- Do not use this apparatus near water.
- Clean only with dry cloth.
- Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
- Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
- Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
- Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
- Only use attachments/accessories specified by the manufacturer.
- Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
- Unplug this apparatus during lightning storms or when unused for long periods of time.
- Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
- This equipment uses AC power which can be subjected to electrical surges, typically lightning transients which are very destructive to customer terminal equipment connected to AC power sources. The warranty for this equipment does not cover damage caused by electrical surge or lightning transients. To reduce the risk of this equipment becoming damaged it is suggested that the customer consider installing a surge arrestor.
- To completely disconnect unit power from the AC mains, remove the power cord from the appliance coupler and/or turn off the circuit breaker. To reconnect power, turn on the circuit breaker following all safety instructions and guidelines. The circuit breaker shall remain readily accessible.
- This product relies on the installation of the building for short-circuit (overcurrent) protection. Ensure that the protective device is rated not greater than: 20A.
- Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage points or short out parts that could result in fire or electric shock.
- This product can interfere with electrical equipment such as tape recorders, TV sets, radios, computers and microwave ovens if placed in close proximity.
The lightning flash and arrow head within the triangle is a warning sign
alerting you of dangerous voltage inside the producd.
Caution: To reduce the risk of electric shock, do not remove cover (or back).
No user serviceable parts inside. Refer servicing to qualified service
personnel.
The exclamation point within the triangle is a warning sign alerting you of
important instructions accompanying the product.
Warning!: To reduce the risk of electrical shock, do not expose this apparatus to rain or moisture
USA & Canada Compliance
FCC Part 15, Subpart B & IC Unintentional Emissions Interference
Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
IMPORTANT! Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
Canada Warning Statement:
- This product meets the applicable Innovation, Science and Economic Development Canada technical specifications.
Europe Compliance
Compliance of this equipment is confirmed by the following logo that is placed
on the product ID label that is placed on the bottom of the equipment. The
full text of the EU Declaration of Conformity (DoC) is available on the
regulatory webpage:
Recycling
Snap One, LLC understands that a commitment to the environment is essential
for a health life and sustainable growth for future generations. We are
committed to supporting the environmental standards, laws, and directives that
have been put in place by various communities and countries that deal with
concerns for the environment. This commitment is represented by combining
technological innovation with sound environmental business decisions.
WEEE Compliance
Snap One, LLC is committed to meeting all requirements of the Waste Electrical and Electronic Equipment (WEEE) directive (2012/19/EC). The WEEE directive requires the manufacturers of electrical and electronic equipment who sell in EU countries: (1) label their equipment to notify customers that it needs to be recycled, and (2) provide a way for their products to be appropriately disposed of or recycled at the end of their product lifespan. For collection or recycling of Snap One, LLC products, please contact your local Wirepath Home Systems, LLC representative or dealer.
United Kingdom Compliance
Compliance of this equipment is confirmed by the following logo that is placed
on the product ID label that is placed on the bottom of the equipment. The
full text of the UK Declaration of Conformity (DoC) is available on the
regulatory webpage:
About this Document
Copyright © 2022 Snap One, LLC All rights reserved. 1800 Continental Blvd.
Suite 300 Charlotte, NC 28273
866-424-4489
snapone.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>