IFIXIT HTC Wizard 200 Motherboard Replacement Instruction Manual
- June 3, 2024
- IFIXIT
Table of Contents
IFIXIT HTC Wizard 200 Motherboard Replacement
INTRODUCTION
Takes you through the steps to install the motherboard.
TOOLS
- iFixit Opening Tool (1)
- Spudger (1)
- T5 Torx Screwdriver (1)
- Tweezers (1)
Motherboard Replacement
Step 1 — Battery
- To expose the battery, remove the outer case with your fingernail.
- Remove the battery by pulling the black tab.
Step 2 — Back Panel
• Insert the flat end of the spudger into the two notches on the back of the
camera cover and pry them up.
Step 3
- Work the spudger around the edges of the camera cover until it comes off.
Step 4
• Remove the four 6 mm screws with the T5 Torx screwdriver.
One of the screws is under the “void” sticker.
Step 5
- Insert the flat end of an iFixit opening tool between the side and inner covers to create a gap.
- Work the tool around the edges until all the clips release.
Step 6
- Once all the clips are open, remove the inner panel from the phone.
Step 7 — Motherboard
- Use the spudger to pry the camera off.
Step 8
- Using tweezers, flip the connector latch away from the motherboard.
• Detach the flexible connection from under the connector latch.
Step 9
- Slide the keyboard into the open position.
Step 10
- Lift the motherboard out of the case using the spudger.
- Expose the underside of the motherboard using your hands.
Step 11
- Remove the flexible connection from the motherboard.
Caution: Removing the connection too fast may cause damage to the connection and cables.
To reassemble your device, follow these instructions in reverse order.
This document was generated on 2022-05-31 06:59:49 PM (MST).
Customer Support
© iFixit — CC BY-NC-SA
www.iFixit.com
References
- iFixit: The Free Repair Manual
- Spudger: The Essential ESD-Safe Pry Tool - iFixit
- T5 Torx Screwdriver: Precision Star-Shaped Bit Driver
- Tweezers: ESD-Safe, Pointed/Angled/Blunt Tips
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>