PUTORSEN PTMA-122 Dual Monitor Stand Instruction Manual
- June 15, 2024
- PUTORSEN
Table of Contents
PUTORSEN PTMA-122 Dual Monitor Stand
Thank You
Thank you for choosing our product! Our dedicated support team can offer immediate assistance with rapid response times. If any parts are received damaged or defective, please contact us. We are happy to replace parts or a brand-new product to ensure you have a fully functioning product. Would you kindly share your experience on Amazon if you are satisfied?
Read the entire instruction manual before you start installation and assembly. If you have any questions regarding any of the instructions or warnings, please contact your local distributor for assistance.
CAUTION: Use with products heavier than the rated weights indicated may result in instability causing possible injury.
- Please closely follow the assembly instructions. Improper installation may result in damage or serious personal injury.
- Safety gear and proper tools must be used. This product should only be installed by professionals.
- Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.
- Use the mounting screws provided and DO NOT OVER TIGHTEN mounting screws.
- This product contains small items that could be a choking hazard if swallowed. Keep these items away from children.
- This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.
IMPORTANT: Ensure that you have received all parts according to the
component checklist prior to installation. If any parts are missing or faulty,
contact your place of purchase for a replacement.
MAINTENANCE: Check that the product is secure and safe to use at regular
intervals (at least every three months).
PTMA-122| VESA Compatible
75×75 100×100| |
---|---|---|---
Package Content
Assembly And Mounting Instructions
Clamp Mounting
Grommet Mounting
CAUTION:
DO NOT use the display beyond the arrow range, avoid tipping.
Note: If the display does not stop at your desired position, tighten the screws as shown.
