IFIXIT MacBook Pro 13 Inch Unibody Mid 2010 Lower Case Replacement Instruction Manual
- June 3, 2024
- IFIXIT
Table of Contents
IFIXIT MacBook Pro 13 Inch Unibody Mid 2010 Lower Case Replacement
Instruction Manual
Replace the lower case in your MacBook Pro 13″ Unibody Mid 2010.
Written By: Walter Galan
INTRODUCTION
Replace the lower case in your MacBook Pro 13″ Unibody Mid 2010.
TOOLS:
- Phillips #00 Screwdriver (1)
PARTS:
- MacBook Pro 13″ Unibody Lower Case (1)
- Macbook Pro Unibody Lower Case Screw Set (1)
- MacBook Pro 13″ Unibody (Model A1278 Mid 2009 Mid 2010) Screw Set (1)
- MacBook and MacBook Pro Unibody Plastic Feet (1)
Step 1 — Remove the lower case screws
- Remove the following 10 screws securing the lower case to the MacBook Pro 13″ Unibody:
- Seven 3 mm Phillips screws.
- Three 13.5 mm Phillips screws.
Step 2 — Lift the lower case away
- Slightly lift the lower case and push it toward the rear of the computer to free the mounting tabs.
To reassemble your device, follow these instructions in reverse order.
This document was generated on 2022-05-26 12:40:19 PM (MST).
© iFixit — CC BY-NC-SA
www.iFixit.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>