SUNLITE 85498-SU 50W Backlit LED Flat Ceiling Panel Light Instruction Manual
- June 3, 2024
- sunlite
Table of Contents
85498-SU 50W Backlit LED Flat Ceiling Panel Light
Instruction Manual
85498-SU 50W Backlit LED Flat Ceiling Panel Light
Please read and understand this entire manual before attempting to assemble,
operate or install the product.
WARNING: Avoid fire or electric shock. Follow installation instructions
carefully. Risk of fire or electric shock. LED Retrofit Kit installation
requires knowledge of luminaires electrical systems. If not qualified, do not
attempt installation. Contact a qualified electrician. Install this kit only
in luminaires that have the construction features and dimensions shown in the
photographs and/or drawings and where the input rating of the retrofit kit
does not exceed the input rating of the luminaire. Wear rubber-soled shoes and
work on a sturdy ladder. Ground fixture to avoid potential electrical shock.
Do not make or alter any open holes in an enclosure of wiring or electrical
components during kit installation. To prevent wiring damage or abrasion, do
not expose wiring to edges of sheet metal or other sharp objects.
CAUTION: Turn off the power at fuse or circuit breaker box before
installation and maintenance to avoid electric shock. This retrofit should be
used on 120-Volt fused circuits. Fixture must be installed according to
National Electric Code and local building codes. If you are unsure about
wiring consult a qualified electrician. THIS FIXTURE BODY IS ONE PIECE, DO NOT
DISASSEMBLE OR MAKE ALTERATIONS. Not to be used for emergency lighting.
Suitable for damp locations. This device complies with part 15 of the FCC
Rules. Operation is subject to the following two conditions:
- this device may not cause harmful inferences, and
- this device must accept any inferences received, including that may cause undesired operation. Retain these instructions for future maintenance reference.
Installation
Installation Steps:
-
Turn off power at fuse box prior to installing.
-
Lift the mounting clip on the edge of panel (Fig. 1), Turn the mounting clip head (Fig. 2), then Put the panel into grid ceiling (Fig. 3). Check the clips well fasten to T-BAR
(Main/Cross ceiling tee) (Fig. 5). -
Remove the Driver Box cover (Fig.6). Open the knockout hole (Fig. ).
-
Insert the cable into driver box (Fig.8), Connect the AC mains power and 0-10V dim cable (if using 0-10V dimming) to LED Driver for 1-10V dimmable panel. hold back the driver box cover (Fig. 9), fix the driver cover (Fig. 10).
-
Restore power at the source.
- Suspension Kit & Ceiling Mounted Frame Kit Are Available, More Detail Please Vest Www.sunlite.com
Sunshine Lighting Company
744 Clinton Street Brooklyn,
NY 11231, USA T. 718.768.7000 F. 718.768.0970
www.sunlite.com
SALE on Sunlite @www.BulbAmerica.com
take additional 5% Off with coupon code 5PDF
Documents / Resources
|
SUNLITE 85498-SU 50W Backlit LED Flat Ceiling Panel
Light
[pdf] Instruction Manual
85498-SU, 50W Backlit LED Flat Ceiling Panel Light, 85498-SU 50W Backlit LED
Flat Ceiling Panel Light
---|---