sunlite 87753-SU Bronze Finish LED Outdoor Wall Mount Fixture Instruction Manual

87753-SU Bronze Finish LED Outdoor Wall Mount Fixture
Instruction Manual

IMPORTANT
READ CAREFULLY BEFORE INSTALLING THE FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes.
Proper grounding is required for safety.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE  CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining the fixture.
No user-serviceable parts inside.

INSTALLATION

1. Open the lens assembly by unscrewing the two screws (Fig. 1).
2. Disconnect the wires between the driver and the LED module (Fig.1).
3. Prepare the back plate for mounting by drilling the appropriate holes (A). ( Fig. 2).
4. Line up the back plate in the desired location and mount it securely. (One gasket was provided for the weather-tight seal between the template and junction box). Pass before the wiring through the appropriate hole of the rear cover.
5. Complete the wiring to the power source and ground.
6. Reconnect the wires between the driver and the LED module.
7. Close the luminaire’s door by tightening the screws (Fig. 1).
8. Caulk the entire perimeter of the luminaire to the mounting surface.

WIRING

Universal voltage driver permits operation at 100V to 277VAC, 50 or 60Hz except fixtures factory ordered with a 120V photocell (/PC).

1. Connect the black fixture line to the (L) Live line supply wire.
2. Connect the white fixture line to the (N) Neutral line supply wire.
3. Connect the green fixture line to the (G) Ground line supply ground.

0-10V DIMMABLE WIRING
Universal voltage driver permits operation at 120V thru 277V, 50 or 60 Hz. For 0-10V Dimming, follow the wiring directions as in fig. 4.

1. Connect the black fixture lead to the (+) LINE supply lead.

2. Connect the white fixture lead to the (-) COMMON supply lead.

3. Connect the GROUND wire from the fixture to the supply ground.
   Do NOT connect the GROUND of the dimming fixture to the output.

4. Connect the purple fixture lead to the (V+) DIM lead.

5. Connect the gray fixture lead to the (V-) DIM lead.

6. Cap the yellow fixture lead, if present. Do NOT connect.

CLEANING & MAINTENANCE:

CAUTION: Be sure the fixture temperature is cool enough to touch.
Do not clean or maintain while the fixture is energized.

1. Clean glass lens with a non-abrasive glass cleaning solution.
2. Do not open the fixture to clean the LED. Do not touch the LED.

TROUBLESHOOTING

1. Check that the line voltage at the fixture is correct. Refer to wiring directions.
2. Is the fixture grounded properly?
   Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during installation, operation, or maintenance.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>