VANMASS A1L56 Car Phone Holder User Manual

VANMASS A1L56 Car Phone Holder

PRODUCT INFORMATION

Phone Mount Assembly

1. Unscrew the nut from the phone holder
2. Insert the nut into the ball joint
3. Push the ball joint into the groove of the holder
4. Make sure the ball joint is fully in the groove and then tighten the nut

Installation Spot

Optional Installation Spots:

• Windshield
• Plastic Dashboard
• Vent

Practical Tips:

• Leather or textile dashboard: NOT compatible, in case of any damage.
• In extreme summer heat: It is recommended to install the suction cup away from direct sunlight.

Clean the flat attaching surface:

1. Wipe with Wet
2. Wipe with Dry

Please make sure the attaching surface is flat, curved mounting surfaces reduce adhesion. Wipe the attaching surface, wet tissue first, dry tissue later.

Suction Cup Installation

1. Peel off the protective film
2. Firmly press the suction cup for 10 seconds
3. Keep pressing while pressing down the suction lock

Phone Mount Adjustment

Angle Adjustment: Please wait 15 minutes before placing your phone for higher adhesion.

Phone Mount Usage

• Release the arms:
• Press:
• Clamp the arms:
• Pull Down:

FAQs

1. How to make the suction cup stick again?
   Please rinse the suction cup bottom, air dry it, clean the attaching surface, and then install the suction cup directly on a flat spot.

2. Do I need to return the product for a replacement or refund?
   No, because our product has a 36-month free warranty for any product issues.

3. Any other questions like below, please reach our service atservice@vanmasslife.com
   For Vent clip installation, suction cup removal tips, and product improvement suggestions.

service@vanmasslife.com www.vanmass.com

Phone Mount Assembly

1. Unscrew the nut from the phone holder
2. Insert the nut into the ball joint
3. Push the ball joint into the groove of the holder
4. Make sure the ball joint is fully in the groove and then tighten the nut

Installation Spot

Optional Installation Spots dashboard or windshield, vertical or horizontal air outlet

Practical Tips

• Leather or textile dashboard: NOT compatible, in case of any damage.
• In extreme summer heat: It is recommended to install the suction cup away from the direct sunlight.

Clean the flat attaching surface

1. Please make sure the attaching surface is flat, curved mounting surfaces reduce adhesion.
2. Wipe the attaching surface, wet tissue first, dry tissue later.

Suction Cup Installation

1. Peel off the protective film.
2. Firmly press the suction cup for 10 seconds.
3. Keep pressing while pressing down the suction lock.

Phone Mount Adjustment

Please wait 15 minutes before placing your phone, for higher adhesion.

Phone Mount Usage

• Release the arms
• Clamp the arms

FAQs

1. How to make the suction cup stick again?
   Please rinse the suction cup bottom, air dry it, clean the attaching surface, and then install the suction cup directly on a flat spot.

2. Do I need to return the product for a replacement or refund?
   No, because our product has a 36-month free warranty for any product issues.

3. Any other questions like below, please reach our service atservice@vanmasslife.com
   Vent clip installation, suction cup removal tips, and product improvement suggestions.

References

• VANMASS | Heartful Service, Golden Quality

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>