eve light switch User Guide
- June 3, 2024
- eve
Table of Contents
eve light switch
Eve Light Switch requires a neutral wire and
replaces a single-pole or 3-way switch. Only for use with copper or copper
clad wire in dry, indoor locations.
If you are unsure or uncomfortable about installing Eve Light Switch, consult
a qualified electrician. To be installed and/or used in accordance with
appropriate electrical codes and regulations. Min. 3 W; Max 1800 W/ 15 A
(resistive), 600 W/ 5 A (incandescent/tungsten), 120 VAC
Get Started
-
Turn off power at the circuit breaker that controls the light switch. Ensure power is off by switching your existing light switch on and off multiple times.
-
Remove your existing wall plate and light switch. Only proceed with the installation if there is a neutral wire !usually white) in the switch box.
-
Replace a single-pole switch
Replace a 3-waya switch
-
Mount Eve Light Switch into the wall.
-
Screw in the snap plate 15a) and push the face plate onto it l5b). Alternatively, use your existing wall plate.
-
Turn on power at the circuit breaker that controls the light switch. Tap Eve Light Switch -your lights should now turn on.
If your lights do not turn on, your live and load wires might be swapped. Turn off power at the circuit breaker and try swapping them.
-
Download the Eve app from the App Store.
Add Accessory
-
Open the Eve app and tap Add Accessory. Eve will now guide you through the setup process.
If you have already set up another accessory, go to the Eve settings to add Eve Light Switch to your home.
Enjoy
Eve Light Switch can be controlled using the Eve app, the Home app, and Siri.
- Control
- View time and duration statistics
- (no Set home schedules hub required)
- Adjust status LED
- Install firmware updates
- Control ac
- Configure guest access
- Control
You can also tap Eve Light Switch to turn your lights on and off. 
Schedules automatically control your lights – completely
autonomously, independently of your iPhone or home hub. Set schedules that
match your daily routine using the Eve app .
Securely access Eve Light Switch while you’re away from home and set up
powerful automations. Any Apple TV HD, Apple TV 4K or Home Pod using the same
iCloud account as your iPhone will automatically serve as a home hub, no
further setup required.
Eve is designed to safeguard your personal data. All data
is fully encrypted and only transferred directly between your Eve Light Switch
and iPhone, iPad or home hub.
Learn more at evehome.com/privacy
Reset
Legal Information
This device complies with part 15 of the FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
- This device may not cause interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates. uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, you are encouraged to try to correct the interference by one or more of
the following measures: reorient or relocate the receiving antenna; increase
the separation between the equipment and receiver; consult the dealer or an
experienced radio/TV technician for help. This Class B digital apparatus
complies with Canadian ICES-003. This equipment complies with FCC RF, IC
RSS-102 and CE radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum
distance of 20 centimeters between the radiator and your body. This
transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Please keep your Home Kit Setup Code in a safe place. You need it to securely
add Eve to your home, and nobody but you has a copy.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>