NOVALUX 55505 2-ft 105W LED Linear High Bay Instruction Manual
- June 3, 2024
- NOVALUX
Table of Contents
NOVALUX 55505 2-ft 105W LED Linear High Bay
PLEASE FIND A QUALIFIED ELECTRICIAN FOR INSTALLATION. Please read the instructions before you install and use the luminaire.
WARNING, CAUTIONS, AND OPERATING INSTRUCTIONS
- To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions, and other hazards read all warnings and instructions included with and on the fixture box and all fixture labels.
- Before installing, servicing, or performing routine maintenance on this equipment, follow these general precautions.
- A qualified licensed electrician should perform commercial installation, service, and maintenance of luminaires.
- For the installation: If you are unsure about the installation or maintenance of the luminaires, consult a qualified licensed electrician and check your local electrical code.
- To prevent wiring damage or abrasion, do not expose wiring to the edges of sheet metal or other sharp objects.
- Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
WARNING: RISK OF FIRE OR ELECTRICAL SHOCK
- Turn off electrical power at the fuse or circuit breaker box before wiring the fixture to the power supply.
- Turn off the power when you perform any maintenance.
- Verify that the supply voltage is correct by comparing it with the luminaire label information.
- Make all electrical and grounded connections in accordance with the National Electrical Code and any applicable local code requirements.
- All wiring connections should be capped with UL-approved wire connectors.
CAUTION: RISK OF INJURY
- Avoid direct eye exposure to the light source while it is on.
- Account for small parts and destroy packing material, as these may be hazardous to children.
- Green ground screw is provided in the proper location. DO NOT RELOCATE.
- Minimum 90° supply conductors.
- Suitable for Dry or Damp locations.
WARNING DISCONNECT POWER BEFORE INSTALLING OR SERVICING.
INSTALLATION
- Remove the new LED fixture from the packaging and inspect for any damages. Handle new LED fixture with care.
- STANDARD CHAIN MOUNT: Install the chain into the provided wire hanger. Secure the other end of the chain to a structure using hardware rated for the load. Install the wire hanger on the side of the top LED channel. Make sure the wiring hangers are fully engaged into the side holes on the top channel.
- Connect the LED high bay wiring to the line voltage wire, black to hot, white to neutral, and green to ground. Use only UL-listed wiring *NOTE: Purple and pink (or gray) wires inside the driver compartment are 0-10V (low voltage) dimming leads. Connect to dimming low-voltage wiring only. If not connecting the fixture to a 0-10V dimming circuit, make sure fixture dimmer leads are capped off separately from each other. Failure to do so make causes improper fixture operation and void the warranty.
- Clean all residues/fingerprints from the new LED high bay and lens. Double-check all hanging hardware before moving on to the next installation.
GENERAL WIRING DIAGRAM
ADDITIONAL MOUNTING OPTIONS (Sold separately)
CABLE MOUNT
PENDENT MOUNT
TONE-SELECT™ LINEAR HIGH BAY – Field Adjustable CCT (If applicable)
The end users may adjust the color temperature by the slide switch located on the side of the driver box. The switch has 2 positions (left or right), corresponding to 1 of 2 color temperatures (4000K, 5000K).
- Switches are located on the side of the fixture.
- Select a color temperature by sliding the switch left or right respectively to the desired value.
Specifications are subject to change without notice. Photos and line drawings may not be to scale and are for general reference only.
PREMIUM QUALITY LIGHTING® • www.PQLighting.com
© P.Q.L., Inc. • 2285 Ward Avenue • Simi Valley, CA 93065 •
800-323-8107.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>