NOVALUX 84045 Led Stealth Fixtures Instruction Manual
- October 27, 2023
- NOVALUX
Table of Contents
LED STEALTH™ FIXTURES
INSTALL INSTRUCTIONS
84045 Led Stealth Fixtures
PLEASE FIND A QUALIFIED ELECTRICIAN FOR INSTALLATION. Please read the instructions before you install and use the luminaire.
WARNING, CAUTIONS AND OPERATING INSTRUCTIONS
- To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions, and other hazards read all warnings and instructions included with and on the fixture box and all fixture labels.
- Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
- Commercial installation, service and maintenance of luminaires should be performed by a qualified licensed electrician.
- For The installation: If you are unsure about the installation or maintenance of the luminaires, consult a qualified licensed electrician and check your local electrical code.
- To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
- Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
- Do not cover any part of the fixture; this can cause overheating.
WARNING: RISK OF FIRE OR ELECTRICAL SHOCK
- Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
- Turn off the power when you perform any maintenance.
- Verify that supply voltage is correct by comparing it with the luminaire label information.
- Make all electrical and grounded connections in accordance with the National Electrical Code and any applicable local code requirements.
- All wiring connections should be capped with UL approved wire connectors.
CAUTION: RISK OF INJURY
- Avoid direct eye exposure to the light source while it is on.
- Account for small parts and destroy packing material, as these may be hazardous to children.
- Suitable for Wet locations.
WARNING DISCONNECT POWER BEFORE INSTALLING OR SERVICING.
Product requires top-mounted shorting cap or optional twist-lock photocell installed to operate.
TRUNNION MOUNTING (POLE)
Place the wires into the box, screw on the back board of the fixture using the M8 x 1.2” screw.
TRUNNION MOUNTING (WALL)
Place the wires into the box, screw on the back board of the fixture using the M8 x 1.2” screw.
Product requires top-mounted shorting cap or optional twist-lock photocell
installed to operate.
SLIP FITTER MOUNTING
POLE MOUNTING
SENSOR INSTALLATION FOR POLE BRACKET
Specifications subject to change without notice. Photos and line drawings may not be to scale and are for general reference only.
PREMIUM QUALITY LIGHTING®
• www.PQLighting.com
© P.Q.L., Inc. • 2285 Ward Avenue • Simi Valley, CA 93065 • 800-323-8107