WORX WX025L 20V Cordless Jobsite Light Instruction Manual

June 3, 2024
Worx

WORX LOGO WX025L WX025L.X
Instruction Manual
WORX WX025L 20V Cordless Jobsite Light -

WX025L 20V Cordless Jobsite Light

WORX WX025L 20V Cordless Jobsite Light - 1WORX
WX025L 20V Cordless Jobsite Light - 2

PRODUCT SAFETY

WARNING: This product can expose you to chemicals including lead and Di(2-ethylhexyl)phthalate (DEHP) which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
CAUTION: Read, understand and follow all Safety Rules and Operating Instructions in this Manual before using this product.

SAVE THESE INSTRUCTIONS!
READ ALL INSTRUCTIONS!
SAFETY INSTRUCTIONS
WARNING: BE SURE to read and understand all instructions in this manual before using this light. Failure to follow all instructions may result in electric shock, fire and/or serious personal injury.

  1. To reduce the risk of injury, close supervision is necessary when a product is used near children.
  2. Do not contact hot parts.
  3. Only use attachments recommended or sold by the manufacturer.
  4. Do not use in the rain.
  5. WARNING: Do not use magnet for horizontal overhead mounting.
  6. WARNING: The lens gets very hot during use. To reduce the risk of burns, do not touch hot lens.
  7. To reduce the risk of electrical shock, do not put + in water or other liquid. Do not place or store product where it can fall or be pulled into a tub or sink.
  8. WARNING: To reduce the risk of injury, do not stare at operating lamp. Serious eye injury could occur.
  9. To reduce the risk of fire, keep away from combustible materials while in operation.
  10. Use only recommended battery pack and charging stand / transformer. Any attempt to use another battery pack will cause damage to the portable hand-held light and could possible explode, cause a fire, or personal injury.
  11. Remove battery pack from the product before performing any routine maintenance or cleaning.
  12. Do not disassemble the product.
  13. Do not place the product or battery pack near fire or heat. They may explode. Also, do not dispose of a worn out battery pack by incineration, even if it is severely damaged or completely worn out. The battery may explode in fire.
  14. Keep light dry, clean, and free from oil and grease. Always use a clean cloth when cleaning.
    Never use brake fluid, gasoline, petroleum-base products or any strong solvent to clean the portable hand-held light.

INFORMATION FOR RADIATED EMISSION
This device complies with Canadian ICES-001.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or manufacturer for help.

SAFETY WARNINGS FOR BATTERY PACK
a) Do not dismantle, open or shred battery pack.
b) Do not expose battery pack to heat or fire.
Avoid storage in direct sunlight.
c) Do not short-circuit a battery pack. Do not store battery packs haphazardly in a box or drawer where they may short-circuit each other or be short- circuited by other metal
objects. When battery pack is not in use, keep it away from other metal objects, like paper clips, coins, keys, nails, screws or other small metal objects, that can make a connection from one terminal to another. Shorting the battery terminals together may cause burns or fire.
d) Do not subject battery pack to mechanical shock.
e) In the event of battery leaking, do not allow the liquid to come in contact with the skin or eyes. If contact has been made, wash the affected area with copious amounts of water and seek medical advice.
f) Do not use any battery pack which is not designed for use with the equipment.
g) Keep battery pack out of the reach of children.
h) Always purchase the battery pack recommended by the device manufacturer for the equipment.
i) Keep battery pack clean and dry.
j) Wipe the battery pack terminals with a clean dry cloth if they become dirty.
k) Battery pack needs to be charged before use.
Always use the correct charger and refer to the manufacturer’s instructions or equipment manual for proper charging instructions.
l) Do not leave battery pack on prolonged charge when not in use.
m) After extended periods of storage, it may be necessary to charge and discharge the battery pack several times to obtain maximum performance.
n) Recharge only with the charger specified by WorxNITRO. Do not use any charger other than that specifically provided for use with the equipment.
o) Retain the original product literature for future reference.
p) Use only the battery pack in the application for which it was intended.
q) Remove the battery pack from the equipment when not in use.
r) Dispose of properly.
s) Do not mix cells of different manufacture, capacity, size or type within a device.
t) Keep the battery away from microwaves and high pressure.

SYMBOLS

| To reduce the risk of injury, user must read instruction manual
---|---
| Batteries may enter water cycle if disposed improperly, which can be hazardous for ecosystem. Do not dispose of waste batteries as unsorted municipal waste.
| Do not burn
| Li-Ion battery,  battery must be recycled
| WARNING – Hot Surface: Risk of Burns – Do Not Touch

POSITEC Inc. has established a partnership with the RBRC Corporation to recycle any Positec batteries with the RBRC-call2recycle seal. For environmental protection, please do not discard batteries in the trash.
After the batteries’ life cycle is ended, please call 1-800-822-8837 for a free service that will properly dispose of the battery

COMPONENT LIST

  1. LED LIGHT
  2. HOOK
  3. PIVOTING HEAD
  4. ON/OFF SWITCH
  5. LANYARD
  6. 20V BATTERY PACK*
  • Not all the accessories illustrated or described are included in standard delivery.

TECHNICAL DATA

  WX025L WX025L.X**
Rated voltage 20V  Max***
Brightness 160/350 LM
Burntime (2.0Ah) High Brightness
Low Brightness 16.5hrs
Pivoting head -6°~+90°
Machine weight ( bare tool) 0.57 lbs (0.26kg)

** X may be followed by one or two characters. All models are the same except model number and trademark.The suffix in models may be number from
“1” to “999” or English letter “A” to “Z” or “M1” to” M9” which means different package or the various of accessories packed in the package.
*** Voltage measured without workload. Initial battery voltage reaches maximum of 20 volts.
Nominal voltage is 18 volts.

SUGGESTED BATTERIES AND CHARGERS

Category Type Capacity
20V Battery WA3575 2.0Ah
20V Charger WA3881 2.0A

We recommend that you purchase your accessories from the same store that sold you the tool. Refer to the accessory packaging for further details. Store personnel can assist you and offer advice.

OPERATING INSTRUCTIONS

NOTE: Before using the tool, read the instruction book carefully.

ACTION FIGURE
BEFORE OPERATION
Charging the battery pack See Fig.A
Installing/Removing the battery pack SeeFig.B,C
OPERATION

Press the ON/OFF switch to turn the light on and off.
WARNING : Do not direct the light beam into eyes.|

See Fig.D1

---|---
Carrying or Hanging the Portable Light|
Utilize the hook to hang the light for illumination.
Warning! Do not hang the Work light on any electrical power cord!
WARNING! The hook is only used to lift the light and is not intended to bear any additional weight or support your weight in any situation| See Fig.D2
Pivoting head adjusts light beam towards working area at a range of -6O to 90o.| See Fig.E

MAINTENANCE

Your tool requires no additional lubrication or maintenance. There are no user serviceable parts in your tool. Never use water or chemical cleaners to clean your tool. Wipe clean with a dry cloth. Always store your tool in a dry place.

CLEANING

Use a dry clean cloth wipe the light and make sure not to use water or immerse the light into water for cleaning.
WARNING: Never use solvents or other harsh chemicals to clean the light. Never let any liquid slide into the light.

WORX LOGOwww.worx.com
Copyright © 2022, Positec. All Rights Reserved.
© Derechos reservados 2022, Positec. Todos los derechos reservados.
AR01645200
1-866-854-WORX (9679)

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals