welldana 34-131045 Mini LED Lamp on Instruction Manual

welldana 34-131045 Mini LED Lamp on

DIMENSION

Contains

Necessary tools for assembly

Options

INSTALLATION INSTRUCTIONS

WARNING

IMPORTANT: This instruction manual contains highly important information about safety measures to be taken when installing and commissioning the device. It is therefore important for you to read these instructions before assembling and operating the product. Please keep this manual for later use. Lack of compliance with the instructions stated in this manual during the installation, operating and maintenance phases shall relieve the manufacturer or distributor of any liability in the face of damages caused to people, to the product, or to the installation site, and will result in you losing the warranty.

GENERAL INFORMATION

This LED light was designed for immersed use in swimming water. It is a class III lighting system with a Safety Extra Low Voltage of ∿12V(AC) or ⎓20V(DC). The light source cannot be replaced. If it stops working, the engine light will need replacing. It has an IP68 protection level and must be installed at a maximum immersed depth of 1 metre. This light also complies with international light safety standards, in particular standard IEC 60598-2-18 pertaining to swimming pool lights. It must be connected to a flexible power lead with a minimum size of 2x1mm².

INSTALLATION

Correct installation requires for the light’s power circuit to be protected by a residual current device, with a maximum intensity of 30 mA. This light can only be connected to a double-insulated transformer or a double-insulated compatible stabilized safety power source. Any other type of voltage transformer is prohibited. We recommend for the transformation power to be higher than the total power of all lights connected to the device. The manufacturer or distributor can in no way be held responsible for the assembly, installation or operation of the product if it was manipulated or if non-provided electrical components were added.

ASSEMBLY AND REPLACEMENT

• Please refer to the instruction sheet provided in this manual.

MAINTENANCE

This LED light does not require any form of maintenance. If the light malfunctions, please contact either our customer service department or of your retailer.

USAGE

This LED light should be used like any traditional incandescent lamp for swimming pools. Commands are given through the main ON/OFF switch on the pool’s electrical panel. You also have the option of connecting a remote control module of the same brand.

SAFETY WARNINGS

• Before working on the light, it must be unplugged from the electrical network
• All electrical connections must be done outside the water
• Never work on the device with wet feet
• All prevention standards currently in force must be complied with
• IEC 364-7-702 standards in particular must be complied with: ELECTRICAL INSTALLATIONS INSIDE BUILDINGS. SPECIAL POOL INSTALLATIONS
• Those in charge of assembly must be suitably qualified for this type of work
• Switching the device off with the remote control will simply put it on standby
• If the device stays off for more than 24h, we recommend using the switch located just before the transformer.

WARRANTY

This LED light is guaranteed against any material and/or manufacturing defects (electronic components) for 2 years starting from the date of delivery. (Substanang documents must be preserved) This light is not guaranteed against breakage caused by an external impact, a short circuit or excessive screwing, nor against power surges caused by the main power network. (In this case, the home insurance policy will kick in). This warranty is valid under the strict condition that the assembly and maintenance instructions are complied with. Within the framework of this warranty, the manufacturer or distributor’s only obligation will be to have their air-sales service replace or repair the product or component recognized as defective for free (the choice is theirs to make). Any other costs are to be covered by the purchaser. To benefit from this warranty, products must first be sent in to the manufacturer or distributor’s are-sales service; their consent is mandatory if the product is to be replaced or repaired. The warranty shall not apply in the case of a visible defect. Defects and deterioration caused by normal wear, malfunctions resulting from non-compliant assembly and/or usage, and product modifications made without the manufacturer’s prior written consent are also excluded from the warranty.

ENVIRONMENTAL INFORMATION

In accordance with European Directive 2002/96/EC, pertaining to waste electrical and electronic equipment (WEEE), the consumer must return any used products to suitable collection points.

Technical features

Input V/Hz

| ~12V(AC)/50~60Hz

⎓20V(DC)/50~60Hz

max

|

540 lumens

± 10%

---|---
P max| 5,4W ± 1%
120°|

471 lumens

±10%

P > 1h| 5,2W ± 1%

PF

| ~12V(AC) = 0,68

⎓20V(DC) = 1

Prog.| 1 colour

SHOULD ONLY BE USED WITH A TRANSFORMER OR SAFETY POWER FEED

WARNING: USE ONLY IN OUTDOOR POOL LAMP NOT SUITABLE FOR ACCENT LIGHTING.

FEATURES

Made in China and imported by Welldana A/S: info@welldana.com

www.welldana.dk

Welldana A/S

• Randersvej 6 DK-6700 Esbjerg
• Phone: +45 75 27 23 33
• Fax: +45 75 27 21 11
• E-mail: info@welldana.com
• www.welldana.com

References

• Welldana Pool & Spa

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>