welldana D37-203310 Liner Inlet 2″x50mm 20mm Eyeball User Guide
- June 3, 2024
- welldana
Table of Contents
welldana D37-203310 Liner Inlet 2″x50mm 20mm Eyeball
PARTS
| N° | AUTRES/OTHERS |
|---|---|
| 1 | ORNX15010 |
| 2 | ORNXVS |
| 3 | ORNX15008 |
| 4 | ORNX15013 |
| 5 (Ø 8) | ORNX15016 |
| 5 (Ø 18) | ORNX15018 |
| 5 (Ø 22) | ORNX15017 |
| 6 | ORNX15009 |
| 8 | ORNX15019 |
| N° | 3310 |
| --- | --- |
| 1+5 | ORAX9543E |
DIMENSION
MASONRY STRUCTURE WITHOUT LINER
- Seal the wall fitting (ref 3350) into the concrete of the basin wall, with the part with the inner threading towards the basin.
- Screw the body of the inlet/outlet or vaccum fitting (7) into the wall fitting component.
- For directional outlet : using the spanner (ref 3390), fit the nut of the rotary joint (6) in the body (7) at the desired height. Then mount the rotary joint (5) and fit the cover on the entire assem bly (1).
POLYESTER STRUCTURE – SHELL
- Proceed as above, using rear nut ref 3394 instead of the wall fitting.
MASONRY STRUCTURE WITH LINER
- Proceed as above, using the wall fitting ref 3352 (sealed into the concrete), adding the flange (3), gaskets (4) and the four big screws (2) in order to ensure a waterproof seal with the liner.
PANEL STRUCTURE
- Proceed as above, using the rear nut ref 3393 instead of the wall fitting, and adding the flange (3), gaskets (4) and the four big screws (2) to ensure a waterproof seal with the liner. Important: instead of fitting the rear nut, you can also install the body (7) outside the swimming pool, and secure it in position using two small thred-cutting screws (2).
WINTERIZING
- For the inlet/outlet fittings, use the winterizing plug 3392 or 3395, or plug 3391.
- For the inlet fittings, use winterizing plug 3391.
- The manufacturer can not be considered as responsible for a direct or indirect damage resulting from an use or an incorrect installation of the product.
- Indicative information, not contractual photos and schema.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>