welldana 34-131015 LED Flad Lampe 60 LED hvid 6500K Instruction Manual
- June 3, 2024
- welldana
Table of Contents
welldana 34-131015 LED Flad Lampe 60 LED hvid 6500K
Dimensioner
Indhold
Alternativ 3 delt installations kit
Installation
IMPORTANT:
this instruction manual contains highly important information about safety
measures to be taken when installing and commissioning the device. It is
therefore important for you to read these instructions before assembling and
operating the product. Please keep this manual for later use. Lack of
compliance with the instructions stated in this manual during the
installation, operating and maintenance phases shall relieve the manufacturer
or distributor of any liability in the face of damages caused to people, to
the product or to the installation site, and will result in you losing the
warranty.
GENERAL INFORMATION
This LED light was designed for immersed use in swimming water. It is a class III lighting system with Safety Extra Low Voltage of ∿12V(AC) or ⎓20V(DC). The light source cannot be replaced. If it stops working, the entire light will need replacing. It has an IP68 protection level and must be installed at a maximum immersed depth of 1 metre. This light also complies with international light safety standards, in particular standard IEC 60598-2-18 pertaining to swimming pool lights. It must be connected to a flexible power lead with a minimum size of 2x1mm².
INSTALLATION
Correct installation requires for the light’s power circuit to be protected by
a residual current device, with a maximum intensity of 30 mA. This light can
only be connected to a double-insulated transformer or a double-insulated
compatible stabilised safety power source. Any other type of voltage
transformer is prohibited. We recommend for the transformation power to be
higher than the total power of all lights connected to the device. The
manufacturer or distributor can in no way be held responsible for the
assembly, installation or operation of the product if it was manipulated or if
non-provided electrical components were added.
ASSEMBLY AND REPLACEMENT
Please refer to the instruction sheet provided in this manual.
MAINTENANCE
This LED light does not require any form of maintenance. If the light malfunctions, please contact either our customer service department, or that of your retailer.
USAGE
This LED light should be used like any traditional incandescent lamp for swimming pools. Commands are given through the main ON/OFF switch on the pool’s electrical panel. You also have the option of connecting a remote control module of the same brand.
Technical features
34-131015
Made in China and imported by:
Welldana A/S – info@welldana.com
www.welldana.dk