VIKING E16W 16000mAh Powerbank Instruction Manual
- June 3, 2024
- VIKING
Table of Contents
VIKING E16W 16000mAh Powerbank
Thank you for choosing a VIKING product. Please refer to the technical specifications of each model in the user manual or on the website www.best- power.cz
OVERVIEW
- USB-C output / input
- USB-A output
- Micro input
- USB-A output
- Lightning input
- Solar charging LED
- Battery capacity status LEDs
- Wireless charging LED on the back of the power bank
- “ON/OFF” button
How to use
Please check that the device is fully charged before using the power bank. The blue LEDs indicate the capacity and charging status.
Battery capacity status
- Since the solar charging starts automatically, LEDs indicate charging if the power bank is on light. A short press of the “ON/OFF button displays the battery charge status.
- The battery charge status is indicated by the 4 LED lights as follows. If only one LED is lit, the powerbank is charged to 0-25%. If 4 LEDs are lit, the power bank is charged to 75-100%. If one LED is blinking, the power bank is discharged.
Charging a solar power bank with solar energy:
- Make sure that the solar panel faces directly towards the sun.
- Charging will start automatically.
- The maximum power of the solar panel is 1.2W
- The power of the solar panel depends on the intensity of the solar light.
- A green LED on the front of the power bank indicates that charging is in progress.
- The power bank continuously recharges its capacity even in artificial light and indirect sunlight, but with reduced power.
Charging a solar power bank from an external power source
The power bank can be charged using a USB-C, micro USB and Lightning cable.
Charging other devices:
- Connect the power bank to the device being charged.
- Multiple devices can be charged at the same time.
- Charging starts automatically.
- If charging does not start automatically, turn on the power bank manually.
Use wireless charging
- Make sure the device you are charging supports wireless charging.
- Turn on the power bank berore using Wireless charging.
- Place the device to be charged on the back of the power bank in the area marked for wireless charging.
- The device to be charged should not be more than 8mm from the power bank.
- Charging will start automatically. The LED on the back of the powerbank will glow green.
- If the LED on the back is red, wireless charging cannot be used. Either no charging device is attached, or the charging device is fully charged, or a foreign object is preventing wireless charging, or the charging device is incorrectly positioned on the powerbank.
LED flashlight control
- Press and hold the “ON/OFF” button until the LED light turns on. Press and hold the “ON/OFF” button again to turn off the LED light.
- A quick double click (2 presses per second) of the “ON/OFF” button will turn on the red/blue warning light on the back of the power bank. Another quick double click of the “ON/OFF” button turns the LED light off.
Notice
- It is common for the body or the backup power supply to heat up during charging and gradually reduce its temperature to room temperature arter charging is complete.
- If you have not used the device for more than 90 days, store it charged to 75% capacity. This will prevent damage to the battery.
- Do not disassemble the product or its accessories.
- Do not modify, disassemble, open, puncture or otherwise tamper with the battery located inside.
- Protect from fire, prolonged direct sunlight and other heat sources to prevent overheating and damage to the product including the battery located inside.
- Protect from contact with water and wet objects, especially when using the product
- Protect from high voltage devices.
- Do not throw or shake the backup power source.
- This unit has a built-in non-removable rechargeable battery. Do not attempt to remove the battery remove the battery to avoid damaging the device
- Do not use chemical cleaning agents to clean the product.
- This device is not intended for use by persons (including children) whose physical, sensory or mental disability or lack of experience and knowledge prevents them from using the device safely. Protect from children!
- When not in use, secure the sockets with safety plugs.
- Stop using this equipment immediately if the product is damaged in any way.
- Use the original power adapter and other accessories for charging.
- In case of ignition, do not use a water extinguisher!
Ignoring the following safety instructions may result in fire, electric shock, or damage to the generator.
TECHNICAL SPECIFICATIONS
Model: | VIKING E16W |
---|
Battery
capacity| 16000mAh/59Wh
| 3.7V
Type| Li-pol
Inputs
USB-C| 5V/3A
Micro USB| 5V/2A
Lightning| 5V/2A
Inputs
USB-A| 5V/3A
USB-C| 5V/3A
Wireless| 5W
Inputs
Product dimensions| 167 x 84 x 34 mm
Mass| 505 g
Solar panel| 1.2W
Material| Tvrzený plast
Accessories| micro USB cabel
Declaration
Do not dispose of the product or batteries at the end of their useful life as unsorted municipal waste, use sorted waste collection points. For more information on recycling this
product, please contact your local council, household waste management organisation or the point of sale where you purchased the product. The product warranty including battery is 24 months from the date of sale. The battery life is 6 months, when under normal and proper use the battery will not drop below 80% of the battery’s real (rated) power LED lifetime is 6 months, where under normal and proper use of the LED lights, a minimum of 80% of the total number of LEDS in the device are guaranteed to be lit.
Loss of warranty
The warranty is void in the event of the following conditions:
- Damage due to improper use, or use under unsuitable conditions.
- Failure to comply with the technical specifications of the equipment.
- Attempt by the user to carry out unprofessional repair or dismantling.
- The equipment or any part thereof is damaged due to natural elements, e.g. lightning, water, mechanical damage, etc.
- The equipment or any part of it is damaged due to unprofessional handling.
More product information
Distribution of the VIKING and TOPDON brands is provided by the company: BONA SPES s.r.o., Řepčín 250, Olomouc 77900, Czechia, IČO: 03476774, DIČ: CZ03476774, VAT No.: 03476774, +420 777 109 009, www.best- power.cz, info@best-power.cz
References
- Design a výroba kiosků - POWER electrical services, s.r.o.
- Power banky, Externí a záložní baterie | Best-PowerBank.cz
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>