LAUNCH LK3-VOLWG-02 Universal Remote Key User Manual
- September 26, 2024
- Launch
Table of Contents
LK3-VOLWG-02 Universal
Remote Key User Manual
Overview:
LK3-VOLWG-02 Universal Remote Key is suitable for vehicle which contains the LAUNCH receiver.
Note: The operating temperature of the product is -20-50°C.
Button description:
| Item | Description |
|---|---|
| 1 | Switch button for mechanical key |
| 2 | Lock button |
| 3 | Trunk button |
| 4 | Unlock button |
Change battery:
First use or when the battery runs out need to change new battery, following steps:
Break open the back side plastic cover to open the remote
Take the battery out and replace new one
Note: The battery type is 2032 with 3V, ensure the positive and negative of
battery is correct.
Install the key same as before
Pairing method:
Pairing with vehicle: Referring to the corresponding vehicle models to match.
FCC statements:
§ 15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
§ 15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
§ 15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
*RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
CE statements:
Frequency Band(s)
This device operates with the following frequency bands and maximum frequency
power.
Note: The product is compliant with these power limits required by the
European Union. Frequency bands supported by the product vary by model.
RFID (433.92 MHz) Max Pe.r.p. is -26.69 dBm.
EU DECLARATION OF CONFORMITY
Hereby, Launch Tech Co.,Ltd. declare that this product with model LK3VO02 is in compliance with Directive 2014/53/EU and 2011/65/EU.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>