welldana ECO-SWIM Control Panel for Jet-Stream Pumps Instruction Manual
- June 3, 2024
- welldana
Table of Contents
welldana ECO-SWIM Control Panel for Jet-Stream Pumps
Electrical connections
Control module
Pilot lights:
- Pump running.
- Overload setting.
- Underload setting.
- Timer setting.
- Alarm.
Operation
Pump thermal protection
At the first start-up, the controller will perform an auto-calibration of thermal protection.
How to repeat Auto-tune
How to change the parameters (Imax, Imin, Timer)
Alarms reset
System status
Alarm messages
- Overload
- Underload
Technical characteristics
- Power supply 230Vac 1/3-ph or 400Vac 3-ph (depending on model) – 50/60Hz
- Protections Overload, Underload, Phase loss, Excessive starting frequency
- Display 4-digit LED
- Air switch For connecting tube with internal Ø 2,.5mm
- Piezo switch 5Vdc, N.O. (pulse)
- Pump output (PUMP) 16A maximum
- Main alarm output (ALARM) 230 or 400Vac, 5A maximum
- Maximum current setting Auto – 0.6…40A (trip in 7 s)
- Minimum current setting OFF – 0.5…40A (trip in 4 s with 20 s starting delay)
- Timer setting OFF – 1’…240’
- Maximum terminal cross-section 4mm² (power) / 2,5mm² (control)
- IP / Temperature IP65 / -10º…+55ºC
- Dimensions (AxBxC) 170x230x120mm
- Software V.1.1
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>