PEM 101 Remote Control User Manual
- June 3, 2024
- Remote
Table of Contents
PEM 101 Remote Control
Product introduction
Technical data
- Power: 3V (CR2032)
- Frequency: 433.92MHz
- Working current: ≤ 20MA
- Operating temperature: – 20 ℃~+60 ℃
- Distance: ≥ 100m (open space)
Warning
- The remote control shall not be affected by moisture or impact, so as to avoid affecting its life.
- In the process of use, when you find that the remote control distance is obviously close or not sensitive, please check whether the battery needs to be replaced.
- Press any button for more than 10 seconds, and the transmitter will stop sending wireless signals.
- Please properly dispose of the used battery according to the instructions
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The user that changes or modifications not expressly approved by the party responsible for compliance could void the user`s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>