Remote Tech RT-JLR1 Electronic Key User Manual
- June 1, 2024
- Remote Tech
Table of Contents
Remote Tech RT-JLR1 Electronic Key
INTRODUCTION
This remote has lock, unlock, Liftgate Unlock Hold Button, Forward button and Backward button, remote start Button, and panic hold buttons; you can lock and unlock the vehicle doors and trunk/hatch with the remote transmitter.
LOCK Button
When you press the LOCK button, it locks all the doors.
UNLOCK Button
Pressing the button unlocks the driver’s door. Pressing the button again
within 5 seconds unlocks the other doors.
TRUNK/HATCH Button
Pressing the trunk or hatch button opens and closes the trunk/hatch.
PANIC HOLD Button
When you press the PANIC button, the vehicle will start sounding the horn and
flushing the hazard lamp. To stop the alarm, press any button on the
electronic key.
Specifications
- FCC ID: 2AOKM-JLR1
- IC: 24223-JLR1
- Models: RT-JLR1
- Part Number: RT-KOBJ
FAQs
What should I do if the remote is not working?
If the remote is not working, try replacing the battery. If the issue
persists, contact customer support for further assistance.
How can I program a new remote key?
To program a new remote key, refer to the user manual for detailed
instructions. It usually involves a specific sequence of button presses on the
existing remote and the new key.
FCC COMPLIANCE STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
IC WARNING
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device