Remote Pro GDS800 Gate Upgrade Receiver Kit Instructions
- May 15, 2024
- Remote Pro
Table of Contents
Remote Pro GDS800 Gate Upgrade Receiver Kit Instructions
GDS800 Instructions
www.remotepro.com.au
- TURN OFF POWER OF MOTOR FROM THE POWER POINT
- View the diagram below and ensure that it matches with the top of your motor.
- Connect the black receiver cable to the left side terminal that is labelled WALL SWITCH by pushing the red tab, inserting the black cable and releasing the tab.
- Connect the blue receiver cable to the left side terminal that is labelled COM by pushing the black tab, inserting the blue cable and releasing the tab.
- Connect the brown receiver cable to the terminal that is labelled +24VDC by pushing the red tab, inserting the brown cable and releasing the tab.
- Turn power back on and ensure the receiver powers up.
- Your two new remotes have been pre-programmed to the receiver. Press button 1 on your new remote to ensure it can operate the door.
WARNING!
This product may contain a coin/button cell battery. Keep product and batteries away from children. Battery can cause severe or fatal injuries in 2 hours or less if swallowed or placed inside any part of the body. Seek immediate medical attention if it is suspected that a coin/button battery has been swallowed or placed inside of any part of the body.
References
- Garage Door Remotes | Car Remotes | Free Shipping AU Wide – Remote Pro
- Garage Door Remotes | Car Remotes | Free Shipping AU Wide – Remote Pro
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>