ULTIMEA Tapio I 2.0 Channel Soundbar User Manual

ULTIMEA Tapio I 2.0 Channel Soundbar

Thank you for purchasing ULTIMEA Tapio I.
This gudie will help you set up so you can enjoy the ultimate sound experience.

1. Power Adapter
2. Optical Cable
3. 3.5mm to RCA Audio Cable
4. Wall Mounting Bolts

DIAGRAM (BUTTONS, PORTS & INDICATOR)

1. Power: Press O.5 second to switch on, hold for 3 seconds to turn off
   Mode: Turn it on and then press O.5 second to switch the mode

2. Short press for next song: Long press for increasing volume

3. Short press for previous song Long press for decreasing volume

4. Play/Pause

5. LED Indicator: Bluetooth Input: be Optical Input: 0PE Aux Input: AUH USB Input: USb

6. USB Input

7. Optical Input

8. 3.5mm Audio Input

9. DC In

Placement
Table placement Place the sound bar on a solid surface

Wall Mounting Installation

REMOTE CONTROL

Battery installation

Use remote control
The working range of remote is + /-30° in both Vertical and Horizontal Direction.

1. Power: Press for 1s to switch on, hold for 5s to turn off, Select
2. Inputs: Bluetooth, Optical, USB and AUX.
3. Five Different EQ Mode: MUSIC, MOVIE, BASS+, NEWS, GAME
   • MUSIC: For music and TV shows
   • MOVIE: For movie and song with deep bass
   • BASS+: For movie with super bass
   • NEWS: For News, talk shws and variety shows
   • GAME: For gaming
4. Loop single/Loop all
5. LED OFF: Please press and hold for 1.5S to turn on/off the power indicator
6. 3D: Turn on/off 3D surround sound effect
7. BTEX: Disconnected Bluetooth, enter the paring mode again.

USING YOUR SOUNDBAR

1. Connect to your TV
   Use Remote Control or Side Buttons of Sound bar to change modes.
   Note: 1

2. Prior to usage, check if your TV has Optical and Aux Output.

3. The sound bar doesn’t have coaxial and HDMI Inputs.

4. Turn on PCM settings of your tv when connected in Optical Mode in case it

5. 32 is the maximum volume ot the sound bar.

6. Connect to other devices

Need to purchase one 3.5mm Audio Cable if your tv has 1 male audio output, the included RCA cable is 1 male to 2 male, will not fit.

3. Bluetooth mode
   
   Short “”press on the remote control or the sound bar, It will enter Bluetooth mode. be Will flash when pairing. be Will stay stable when Connected successfully.

SPECIFICATION

Safety Instructions

1. Avoid dropping
2. Do not disassemble
3. Avoid extreme temperatures
4. Don’t use the device outdoors during thunderstorms
5. Use original or certified cables
6. Don’t use any Corrosive cleaner/ oil to clean
7. Copy fisht

FCC Regulatory Compliance

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help

Warning. changes or medications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

RF Exposure Compliance

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Correct Disposal of This Product (Waste Electrical& Electronic Equipment) This mark shown on the product or its packaging, indicates that this product should not be disposed with other household waters at the end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal. please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources.

Household user should contact ether the retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmentally safe recycling. Business users should contact their supplier and check the terms and Conditions of the purchase contact. This product should not be mixed with other commercial wastes for disposal.

ULTIMEA EU Representative: SHUNSHUN GmbH
Address: Römeräcker 9 Z2021, 76351 Linkenheim-Hochstetten, Germany UK Representative: UK CROSSBORDER LIMITED
Address: 7 Bell Yard London Wc2A 2JR, UK United Kingdom Manufacture
Name: GuangDong Substanbo Technology Co., Ltd.
Address: 2508, Building 4, Tianan Cloud Park Phase Il, Bantian Street, Longgang District, Shenzhen, China 518100

Support@ultimea.com
www.ultimea.comn
@Ultimea
Made in China

References

• Ultimea ­– Affordable Soundbars, Projectors and Home Audio Systems

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>