EKVIP 022521 Inflatable Snowman Family Instruction Manual
- June 3, 2024
- EKVIP
Table of Contents
EKVIP 022521 Inflatable Snowman Family
SAFETY INSTRUCTIONS
- Do not connect the product to a power point while the product is still in the pack.
- Intended for indoor and outdoor use.
- Check that no light sources are damaged.
- Do not connect two or more string lights together electrically.
- No parts of the product can be replaced, or repaired. The whole product must be discarded if any part is damaged.
- Do not use sharp or pointed objects during assembly.
- Do not subject the power cord or wires to mechanical stress. Do not hang any objects on the product.
- This is not a toy. Do not allow children to play with the product.
- Be careful if using the product near children.
- Disconnect the transformer from the power point when the product is not in use.
- This product must only be used together with the supplied transformer and must never be connected directly to the mains supply without a transformer.
- The product is not intended to be used as general lighting.
- Recycle products that have reached the end of their useful life according to local regulations.
WARNING!
The product must only be used when all the seals are correctly fitted.
SYMBOLS
- Read the instructions.
- Safety class III.
- Approved in accordance with the relevant directives.
- Recycle discarded product in accordance with local regulations.
TECHNICAL DATA
- Input voltage, transformer 230 V ~ 50 Hz
- Output voltage, transformer 12 V DC
- Output 12 W
- Safety class III
- Protection rating IP44
- Ambient temperature -10 – 70 °C
USE
- Remove the product from the packaging.
- Spread out the product at the required place.
- Make sure that the zip on the bottom of the product is closed.
- Connect the fan to the transformer.
- Plug the plug into the mains power supply. The fan starts automatically.
- Lift up the product a little so that it fills up more quickly with air.
- Check that the product is stable when inflated.
- Fasten the lines in the eyelets on the side of the product.
- Attach the lines in the anchoring pins.
- Secure the anchoring pins in the ground.
- The product must be disconnected from the mains power supply when deflated. The air comes out more quickly if the opening in the bottom is opened.
NOTE: A few weights can be placed on the bottom of the product to make it more stable.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>