KODLiN K68496 3-1 Sleek Rear Indicataors Instruction Manual
- June 3, 2024
- KODLin
Table of Contents
KODLiN K68496 3-1 Sleek Rear Indicataors Instruction Manual
Installation Instructions
-
Remove both saddle bags and seat.
-
Remove antenna mounting hardware from left/right fender strut and the rubber grommet/plugs if used.
See picture #1
Note: You will need to relocate your antenna if you want to continue receiving AM/FM signals. -
Unplug license plate and taillight harness from right side of rear facia light.
-
Remove license plate/turn signal light bar from fender.
-
Unpackage your Sleek lights and remove the retaining plate from the back. Insert LED into housing with round opening then apply small amount of medium strength thread locker on stud. Place lock washer and nut over the stud and tighten snugly but do not over tighten. This will hold insert onto the housing. See picture #2
-
Place housing into opening for antenna feeding wires to back side. Using thread locker on two small screws provided install retaining bracket onto back side of LED housing. Check for proper alignment and tighten down snugly. See picture #3 and #4
-
Repeat steps 5 and 6 for other side.
-
When wiring we suggest you tie into existing harness in this location. See pic #5
a. LED black wire (ground) to harness black wire
b. LED yellow wire (running) to harness blue wire
c. LED blue wire (turn) to harness blue/violet (left turn) wire, blue/brown (right turn) wire.
d. LED red wire (stop) to harness blue/red wire.
Note: We offer a kit and Namz has a kit to tie into existing harness at this location to run required wires when adding LED lights. See web site for details.
-
Replace license plate mount, follow instructions for mounting provided with the mount.
-
Test for proper operation.
-
Re-install seat and saddle bags.
For the latest install guides, video’s, FAQ’s. and Tech-Tip’s scan QR code!
Revision Date: 4/15/2022
www.kodlinusa.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>