KODLin Rear LED Install Kit KUS11500 for Harley-Davidson M8 Softails Installation Guide
- June 3, 2024
- KODLin
Table of Contents
KODLin Rear LED Install Kit KUS11500 for Harley-Davidson M8 Softails
Kodlin Rear LED Install Kit KUS11500 for Harley-Davidson® M8 Softails®
Kit Contents
- 1 – M8 S/T Rear Harness w/KUS11400
- 8 – Micro Posi-Locks
- Instructions
Removal
- Remove the right side cover and disconnect your negative battery cable.
- Remove seat.
- Unplug the two left and right turn signal harness connectors and the taillight/license harness connector if used.
- Remove all zip ties or harness ties before removing the rear fender.
- Loosen the two fender strut mounting bolts from each side.
- Remove the rear fender and set it on a protective surface to prevent scratching.
- Remove fender struts and install rear LEDs according to their instructions.
Install
Tip: Go to https://kodlinusa.com/tech-guide/#installation-guide for examples of how to wire for your type of
taillight setup.
- Determine the length of wire required for LED install and trim LED wiring and install kit wiring per your length requirements. The longer wire group, channel 2, routes to the left side of the fender.
- Trim approximately ¼” of insulation from wire tips and install wire thru the center of the posi-lock screw-on end piece.
Tip: I usually leave 1/16” of wire sticking past the inside of the screw-
on tip to insert into a centerpiece of the post-lock. Make sure no bare wire
is visible past the outer edge of the post-lock. Picture
1.
Wrap or dress your wires as needed and install the fender strut back onto the
fender for both sides. Install rear fender assembly. Connect your connectors
and verify your wire routing is free from any moving parts and that you have
enough length to plug back into the main harness. Picture 2. Start out with
Dip Switches all set to “ON” or P setting. Settings K-P seem to work well with
HD Can-Bus. I usually set both channels to the same Ohm level settings, but
you can set DIP switches 1-4 on one Ohm value and Dip Switches 5-8 on another
since 1-4 is for channel 1 and 5-8 is for channel 2. Picture 3 and 4. Connect
your battery and test to make sure there are no hyper flashing or DTC error
codes. Increase the Ohm value with Dip Switches if so and test again until you
have no more issues. Make sure to clear your DTC codes when finished. Verify
all your bolts are torqued properly and go ride.
For the latest install guides, videos, FAQ., and Tech-Tip scan the QR code!
Revision Date: 8/25/2021 www.kodlinusa.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>