LEDLUX GL-RC-006z RGB+CCT Remote Control User Guide
- June 3, 2024
- LEDLUX
Table of Contents
LEDLUX GL-RC-006z RGB+CCT Remote Control
RGB+CCT Remote Control
This manual describes RGB+CCT remote contra used far our RGB+CCT products Remote contra can contra the LED lights up to six different Zones, change the color, dim/brighten the lìghts, warm/cool white, and different programs. In this manual, you will learn.
Technical data
- Size:18x55xl30mm
- Material: PC
- Transmitting Power: 6dB
- Modulation Method: GFSK
- Programs:9 kinds
- Power: 3V(AAA battery*2pcs)
- Standby power: lSμA
- Working Temp: -20°C~60°C
- Max contrai Range: 20m
- RF Frequency: 2.4GHz
- Warranty:2 Years
Battery Installation
Please take the remote control and carefully press the battery cover and push
it away in a downward motion. Install two AAA batteries, and exactly match the
negative ( – } pole of each battery to the largest spring. Don’t touch the
color ring when you install the batteries. Place the battery cover back and
install it tightly.
How to link & use
- Within 3 seconds after power on, click the “on” button of the group to conduct code matching, and the LED light turns green, indicating successful code matching.
- Long press the “off” button of the remote control to enter the night light mode, and the brightness and color can stili be adjusted at this time.
- long press the small moon key to enter the 60 seconds delay shutdown state.
- Long press M key to enter automatic mode.
How to unlink
- If the LED is stili connected to the Zig Bee gateway, long press the “on” button on the remote control within 3 seconds after power on or press the button for 5 times continuously, the light will flash for 5 times in the current color;
- If the LED is not connected in the Zig Bee gateway state, long press the “onK button on the remote control within 3 seconds after power on or press the button for 5 times continuously, then the LED light will be fully bright and flashing for 5 times;
Mode description
- Mode 1: Static warm light (warm light alone)
- Mode 2: Static white light (cold light and warm light are equally bright)
- Mode 3: Static cold light {cold light alone)
- Mode 4: Static red light
- Mode 5: Static green light
- Mode 6: Static blue light
- Mode 7: RGB fade in fade out (Color fade in fade out from red to green, then to blue, then to red, and so on, speed adjustable.)
- Mode 8: RGB flash {Color flash from red to green, then to blue, then to red, and so on, speed adjustable.)
- Mode 9: Color breathing (In this mode, the brightness of the current color will cycle from 100%-0%, then from 0%-100%. At the same time, you can switch color and have a cycle repeatedly. Press the switch /mode button to exit this mode.)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>