LEDLUX CL2290F10 Flexible PCB Memory Touch Switch Dimmer Instruction Manual
- October 30, 2023
- LEDLUX
Table of Contents
CL2290F10 Flexible PCB Memory Touch Switch Dimmer
Instruction Manual
Functions
- Touch switch ON/OFF with dimming and memory.
- Input Voltage: 12V-24V DC.
- lnput wire outer diameter: 1.9mm MAX
- Output Voltage: 12V-24V DC.
- LED Strip Width: 10mm
- lnput Current: 3A.
- Load around 36W for 12V, and 72W for 24V.
- Dimension: 50*10mm.
- Height of Spring: 20mm.
| V+ | DC input positive |
|---|---|
| V- | DC input negative |
| LED+ | Output to LED Strip positive |
| LED- | Output to LED Strip negative |
Operations
- The conductive spring needs to be covered by insulation material such as glass, plastic or ceramic material, thicknesss3mm.
- With memory internal switch on/off and dimmer:
- Originally “OFF when the power is connected.
- Quick touch (time is less than 550ms) can turn the light on and off. One touch to turn on; Mother touch to turn off. The lamp is 90% bright when it is on.
- Hold on touching (time is above 550ms) can adjust the brightness endlessly; It will reduce the brightness endlessly to the minimum in 3 seconds holding on when the light on.
- Quick touch and hold on touching can be chosen anytime without any collision.
- This sensor will memorize the status of the dimming in DC12V-24V.
Installation Steps
Note:
- Height Requirement of Spring: Cut the Spring 5mm above the PC Cover. It is easy to cause a short circuit if the spring is too long with the PC cover is installed.
- The function/program can be customized, made different needs, such as longer time for stay on, etc.
REV:A0
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>