atom AT9087 LED Downlight Installation Guide
- June 3, 2024
- ATOM
Table of Contents
INSTALLATION SHEET
LED DOWNLIGHT
AT9087/TRI SERIES II
12W/16W/24W/30W LED downlight with dimmable driver
Tri,,T 1A/hih,
Product Specification
Voltage | 230V~ 50Hz |
---|---|
Light colour options | Warm white |
Colour temperature | 3000K |
Lumen output | 12W |
16W | 1840lm |
24W | 2770lm |
30W | 3860lm |
Colour Rendering Index | >80 |
--- | --- |
Beam Angle | 60° |
Dimmable | Yes* |
Warranty | 3 Years |
Working Temperature | -10°C – 40 °C |
IP Rating | IP44 (front face) IP40 (behind ceiling) |
IC Rating | IC-4 IC-F (NZ) |
Electrical classification | Class II |
Wiring | Flex and Plug |
*Compatible with selected leading and trailing edge dimmers.
Product range
Code | Wattage | Dimensions (mm) | Cut out (mm) |
---|---|---|---|
AT9087/12/WH/TRI | 12W | H55 / Ø145 | Ø120-130 |
AT9087/16/WH/TRI | 16W | H58 / Ø170 | Ø150-160 |
AT9087/24/WH/TRI | 24W | H60 / Ø190 | Ø160-170 |
AT9087/30/WH/TRI | 30W | H60 / Ø228 | Ø200-210 |
SAFTEY INFORMATION
Luminaires must be installed and fitted by a qualified electrician ensuring
the installation complies to the current wiring regulations.
The LED’s in this downlight CANNOT BE REPLACED. Ensure all electrical
connections are secure and that there are no loose strands.
Do not install this product on damp or newly plastered ceilings. Always ensure
there is adequate ventilation around the driver at all times.
This product may contain substances that can be hazardous to the environment
if not disposed of properly. Electrical and electronic equipment should never
be disposed of with general household waste but must be separated of it’s
correct treatment and recovery. Where possible recycle your packaging. Please
keep these instructions safe for future reference.
Installation
Read instructions and check you have all the tools and accessories to complete the installation correctly. This product is dimmable with selected leading and trailing edge dimmers. It is recommended that you only use the endorsed dimmer brands. Please consult your lighting provider before installation
- A. Isolate the mains power supply before commencing installation. B. Cut hole in desired position.
- Feed mains cable through cut-out and plug into mains supply
- Connect fitting to LED driver.
- Set desired LED colour temperature on the LED Driver
- Fold spring clips and push into cut-out.
- Fit downlight into ceiling cut-out.
- Ensure correct lighting installation, switch power supply on.
|
---|---
Risk of Fire
CAN BE COVERED AND ABUTTED
HCB = Minimum distance between the top of the recessed luminaire and any
building element above it.
MIC = Minimum distance between the top of the recessed luminaire and the
building insulation above it.
SCB = Minimum distance between the side of the recessed luminaire and any
building element.
SCI = Minimum distance between the recessed luminaire and any building
insulation.
SCG = Side clearance to auxiliary equipment [control gear (CG)] Combustible
building element above fitting
Risk of Fire – Required clearance from structural members and building elements.
HCB: 0mm | MIC: 0mm | SCB: 0mm | SCI: 0mm | SCG: 0mm |
---|
CONTROL GEAR
An independent controlgear that can be used where normally flammable materials, including building insulation, are or may be present, but cannot be abutted against any material and cannot be covered in normal use.
HCB: 25mm | MIC: 10mm | SCB: 25mm | SCI: 15mm |
---|
Warning: Risk of overheating or fire if the clearance , distances are
compromised.
Driver models supplied with the AT9087
Code | Description |
---|---|
AT9087/DRIVER/12 | 12W LED Driver Constant Current Dimmable |
30-40Vdc 300mA
AT9087/DRIVER/16| 16W LED Driver Constant Current Dimmable
30-40Vdc 400mA
AT9087/DRIVER/24| 24W LED Driver Constant Current Dimmable
30-40Vdc 600mA
AT9087/DRIVER/30| 30W LED Driver Constant Current Dimmable
30-40Vdc 750mA
Warranty
Atom products are distributed in Australia by Atom Pty Ltd (Atom). The
Australian Consumer Law as well as other Australian laws guarantee certain
conditions, warranties and undertakings, and give you other legal rights, in
relation to the quality and fitness for purpose of Atom products sold in
Australia.
In Australia, our goods come with guarantees that cannot be excluded under the
Australian Consumer Law. You are entitled to a replacement or refund for a
major failure and compensation for any other reasonably foreseeable loss or
damage.You are also entitled to have the goods repaired or replaced if the
goods fail to be of acceptable quality and the failure does not amount to a
major failure. What constitutes a major failure is set out in the Australian
Consumer Law.
Nothing in this Warranty purports to modify or exclude the conditions,
warranties and undertakings, and other legal rights, under the Australian
Competition and Consumer Act and other Australian laws. Atom products are
warranted in Australia for a period specified on packaging from the date of
delivery of the product, provided that the products are properly stored,
installed, used and maintained in accordance with the instructions contained
within their manual.
Products that have been altered in any way or used other than in accordance
with their instructions are not covered by this Warranty.
This Warranty is not transferable and is valid only in the hands of the
purchaser of the product. The warranty does not cover Atom products other than
those purchased from Atom. Proof of purchase must be provided to Atom with any
warranty claim. Atom recommends that the purchaser attaches their proof of
purchase to their product manual.
If you wish to claim under this Warranty, you must, at your own expense,
return the product or that part of the product which you believe is defective,
and proof of original purchase, your name, address and telephone number and a
certificate installation or other document required by the law for the
installation of electrical products in the place in which the product was
installed, to Atom at the address above within the warranty period from the
date of purchase.
Please note that the Warranty does not cover removal or re-installation of the
product or that part of the product which you believe is defective.
Atom’s total liability under this Warranty is limited to the cost of repair or
replacement of the faulty product. Atom may satisfy its obligations under this
Warranty in full by repair or replacement of a faulty product. This Warranty
does not apply to consumable items such as lamps or batteries or other items
that can be classified as consumable.
For the avoidance of any doubt, any and all warranties or conditions which are
not guaranteed under the Australian Competition and Consumer Act or the
Australian Competition and Consumer Regulations 2010 and which are not
expressly included in this Warranty as additional warranties or conditions are
excluded.
This Warranty does not cover loss or damage caused by wear and tear, misuse,
incorrect installation or operation, failure to clean and maintain, incorrect
voltage or non-authorized electrical connections, adverse external conditions
(such as power surges and dips, acts of God, exposure to heat, corrosion,
insect or vermin infestation), use of non-authorized or defective parts or
globes, or to items that have been repaired other than by Atom or a repairer
approved by Atom.
Atom Lighting Pty Ltd
Atom is a registered brand of Evolt PTY Limited.
For further information please call Evolt’s head office on 1300 4EVOLT (438
658).
Evolt PTY Limited PO BOX 271 KINGSGROVE NSW 1480
ABN 83 112 123 529
Due to changes in industry standards and Atom’s policy of continual product
development,
product specifications are subject to change without notice.
Images are for illustrative purposes only Atom Lighting is an Evolt Company.
a brand of
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>