aranet NH3 Sensor Kit Instruction Manual

: June 3, 2024
: Aranet

Table of Contents

aranet NH3 Sensor Kit
What is included in the Aranet NH3 kit?
Assembling the kit
Third step: connect the kit to the mains power cable
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

aranet NH3 Sensor Kit

What is included in the Aranet NH3 kit?

NH3 kit consists of Aranet 0-10 VDC transmitter with a 24 VDC power supply (datasheet) and a DOL53 Ammonia sensor (datasheet), as well as relevant details for the sensor and transmitter to be connected. The cable to connect the transmitter to the mains power is not included.

aranet NH3 Sensor Kit 1

Assembling the kit

Things to know before starting the pairing procedure

It is possible to pair the transmitter to the base station with or without the sensor connected.
To pair the transmitter, the transmitter must be near the base station (max 20 m).
Pairing the sensor with the battery ensures an interrupted signal to the base station during the whole installation process, as well as connection to the sensor in case of an electricity outage or sensing element failure.
When installing and placing the sensor note that the cable must be routed in a manner to obtain a
“water/drip loop” for water to drop off. Do not stress the cable.
If you experience any difficulties, get in touch with support@aranet.com.

First step: how to pair the transmitter to the base station with batteries (recommended)

Have the transmitter (lid opened) and 1x AA battery ready.
Unscrew and take off the transmitter’s lid.
Open the Sensorhub application (ensure that you have the latest firmware upgrade).
Open the section “SENSORS” and there choose the preferable measurement interval.
Click the “PAIR SENSOR” button on the computer screen and then immediately insert the batteries or insert batteries and click the “PAIRING” button on the transmitter (left corner).
The sensor will be paired and appear in the category “SENSORS”.
You can finish your sensor setup and screw the lid back

Second step: connect the transmitter to the sensor Connect the DOL53 sensor to the Aranet transmitter with the cable included in the installation kit. Connect the wires to the terminals in the junction box.

aranet NH3 Sensor Kit 2

Aranet 0-10 V transmitter with 24 VDC power supply| DOL 53 NH 3 sensor
---|---
Slot no. in the

junction box

| | Corresponding

wire color

Third step: connect the kit to the mains power cable

Make sure the cable is not connected to the power mains. Unscrew and take off the transmitter’s lid.
Connect the cable to the transmitter as shown in the scheme below.
To ensure high IP protection, the cable must be directly connected to mains power.
After finishing the assembly, tighten the cable glands to ensure water protection.
Screw back the transmitter’s lid.

Connection to mains power	Wires
N – Neutral	Blue
L – Live	Brown
GND*	Green/yellow

aranet NH3 Sensor Kit 3

FOR MORE DETAILED INFORMATION ABOUT ARANET PRODUCTS, PLEASE VISIT ARANET.COM, CONTACT YOUR ARANET REPRESENTATIVE OR WRITE TO INFO@ARANET.COM. PRODUCT SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT PRIOR NOTICE.
© 2022 SAF TEHNIKA, JSC. ALL RIGHTS RESERVED.