aranet Transmitters with Power Supply User Guide
- June 3, 2024
- Aranet
Table of Contents
aranet Transmitters with Power Supply
About the transmitters
Aranet offers four different transmitters that can be connected with third- party sensors and thus integrated into the Aranet ecosystem. Transmitters themselves are battery-powered, but can also be connected to mains electricity to power the third-party sensor.
Visual 1: Aranet transmitter
- Aranet 4 – 20 mA transmitter with 12 VDC power supply (datasheet)
- Aranet 4 – 20 mA transmitter with 24 VDC power supply (datasheet)
- Aranet 0 – 10 V transmitter with 12 VDC power supply (datasheet)
- Aranet 0 – 10 V transmitter with 24 VDC power supply (datasheet)
Pairing the transmitter with the base station
Things to know before starting the pairing procedure:
- It is possible to pair the transmitter to the base station with or without the sensor connected.
- To pair the transmitter, the transmitter must be near the base station (max 20 m).
- When installing and placing the sensor note that the cable must be routed in a manner to obtain a “water/drip loop” for water to drop off. Do not stress the cable.
- If you experience any difficulties, get in touch with support@aranet.com.
Option 1: How to pair the transmitter to the base station with batteries
(recommended)
Pairing the sensor with the battery ensures an interrupted signal to the base
station during the whole installation process, as well as in case of an
electricity outage or sensing element failure.
- Have the transmitter and 1x AA battery ready.
- Unscrew and take off the transmitter’s lid.
- Open the Sensorhub application (ensure that you have the latest firmware upgrade).
- Open the section “SENSORS” and there choose the preferable measurement interval.
- Click the “PAIR SENSOR” button on the computer screen and then immediately insert the batteries or insert batteries and click the “PAIRING” button on the transmitter (left corner).
- The sensor will be paired and appear in the category “SENSORS”.
- You can finish your sensor setup and screw the lid back.
Option 2: How to pair the transmitter to the base station with mains power, without batteries
- Connect the power cable to the transmitter.
- Unscrew and take off the transmitter’s lid.
- Connect it to the power mains.
- Open the Sensorhub application (ensure that you have the latest firmware upgrade).
- Open the section “SENSORS” and there choose the preferable measurement interval.
- Click the “PAIR SENSOR” button on the computer screen and then click the “PAIRING” button on the transmitter (left corner).
- The sensor will be paired and appear in the category “SENSORS”.
- You can finish your sensor setup and screw the lid back.
| Connection to mains power | Cables |
|---|---|
| N – Neutral | Blue |
| L – Live | Brown |
| GND* | Green/yellow |
*The wire should be clipped at the end.
Visual 2: Connecting power cable to the transmitter
Finishing up the installation of the transmitter
If needed, the sensor can be either placed on a clean surface or attached to a
wall.
- Unscrew the transparent lid of the transmitter.
- To attach the transmitter to a wall use the 4 mount holes in each corner of the body transmitter.
- Screw the transmitter to the wall.
- Attach the transparent lid back.
FOR MORE DETAILED INFORMATION ABOUT ARANET PRODUCTS, PLEASE VISIT ARANET.COM,
CONTACT YOUR ARANET REPRESENTATIVE OR WRITE TO
INFO@ARANET.COM. PRODUCT SPECIFICATIONS ARE SUBJECT
TO CHANGE WITHOUT PRIOR NOTICE.
© 2022 SAF TEHNIKA, JSC. ALL RIGHTS RESERVED.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>