Milesight UG63 i-Box CoWork Kit User Guide

: June 4, 2024
: Milesight

Table of Contents

Milesight UG63 i-Box CoWork Kit
Device List
Packing List
Registration and Activation
Setting up the Gateway
Setting up the WS Series Device
Setting-up VS121 Sensor
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Milesight UG63 i-Box CoWork Kit

Device List

Milesight-UG63-i-Box-CoWork-Kit-fig-1

Packing List

Milesight-UG63-i-Box-CoWork-Kit-fig-3

Registration and Activation

Open a web browser, and navigate to cloud.milesight-iot.com to register a Milesight IoT Cloud account. You can also install Milesight IoT Cloud App from Google Play or the App store.
Activate the account to the pro 1 plan by entering the activation code on the web GUI. You can contact your sales representative to get the activation code.

Setting up the Gateway

Power on the UG63 via PoE or type-C port.
Connect the UG63 gateway to PC via Ethernet port or PoE Switch and configure the IP address of the computer to the same subnet with the UG63 gateway manually
(e.g. 192.168.23.200).
Type 192.168.23.150 into the browser on PC to log in the web GUI of the UG63 gateway.
Username: admin
Password: password
Enable the network server and Milesight IoT Cloud mode.
Select the Connection Type of Ethernet port and fill in the IP information, then connect UG63 gateway Ethernet port to network devices like a router or a modem to get Internet access.
Fill in the device SN to add a gateway and ensure the gateway is online. You can also enter the SN manually on the Cloud App to add the gateway.

Setting up the WS Series Device

Pull out the battery insulating sheet to power on WS series sensors.
Use an NFC-enabled smartphone to install Milesight ToolBox App from Google Play or App store, place the NFC area of phone close to the device and use Milesight ToolBox App to read and configure the device. Milesight ToolBox App:
Fill in the device SN to add the device on the Milesight IoT Cloud page. You can also use Cloud App to scan the QR code on the label of the device to add or fill in the device SN manually to add the device.
After devices are getting online, you can view the data on the cloud.
Fix sensors to the wall via 3M tapes or wall mounting kits. Fixed by 3M Tapes:

Fixed by Screw：

Note:
For WS301, the plane distance between sensor and magnet should not be more than 15 mm, and the height difference should be less than 7.5 mm. www .milesight-iot.com.

Setting-up VS121 Sensor

Power on the VS121 sensor via the type-C port.
Search and connect the Wi-Fi SSID of VS121(SSID can be found on the label of the device), then open the browser and type 192.168.1.1 to access the web GUI.
Select the language and set the password to log in to the web GUI, then complete the sensor settings.
Fill in the device SN to add the device on the Milesight IoT Cloud page. You can also use Cloud App to scan the QR code on the label of the device to add or fill in the device SN manually to add the sensor.
Use a mounting sticker to mark the mounting holes and fix the sensor with wall mounting kits. Installation requirement: the height should be 3m, and the thickness of the ceiling should be more than 30mm.