axi A030.136.XX Double Swing Double Swing Wall Mounted User Manual
- June 13, 2024
- AXI
Table of Contents
axi A030.136.XX Double Swing Double Swing Wall Mounted
Single Swing / Single Swing Wall-mounted
- A030.136.XX / A030.145.XX
Double Swing / Double Swing Wall-mounted
- A030.135.XX / A030.144.XX
Nest Swing / Nest Swing Wall-mounted
- A030.134.XX / A030.143.XX
- Attention, only for domestic use”
- Keep instructions tor later use
WARNING
THE TOY IS TO BE ASSEMBLED BY AN ADULT.
SWING PARTS
SWING ASSEMBLY
Parts:
- – 5
- -7 (x 4)
Put 4 swing hooks (7) in the beam (5). lf you have a single swing, you only
have to put 2 swing hooks in the beam.
Parts:
- 1
- b8
- c4
Lay the pole (1) on the ground, with the notch upwards. Put a flat was her (
c4) over the bolt (b8), and put the bolt through the hole of the pole (1) and
the hole of the beam.
Parts:
- 2
- c4
- m5
Now put the bolt through the hole of the other pole (2). Put a flat was her (
c4) over the bolt and tighten it wit a hex nut (m5).
Parts:
- 1
- 2
- b8
- c4 (x2)
- m5
Do the same for the other side.
Now carefully lift up the frame, so that it stands on the 4
poles.
Before you screw the planks and the braces to the frame, make sure the outer
dimensions are 254 x 160 cm. Then tighten the bolts and the hex nuts
again.
Parts:
- 3 (x2)
- 4 (x2)
- s2 (x24)
Screw the 4 planks (3 + 4) to the frame. Make sure they are horizontal and
that the sides of the planks align with the sides of the poles.
Parts:
- 6
- s2 (x4)
Screw the brace (6) to the frame. Make sure the sharpest corner (40°) of the
brace points downwards!
Parts:
- 6
- s2 (x4)
Screw the other brace (6) to the other side of the frame.
Parts:
- 8 (x2)
- 9 (x4)
Use the ground anchors (9) to secure the frame to the ground. Attach the swing
seats (8) to the swing hooks. 
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>