spex Stylo Heavy-Duty Compatibility Kit Installation Guide
- June 3, 2024
- spex
Table of Contents
spex Stylo Heavy-Duty Compatibility Kit
This is a supplementary installation guide, for full information and warnings refer to Head Support User Manual provided with your Head Support.
Installation
- Attach the Mounting Block to the Stylo HDCK Plate, using the M6 x 25mm screws and washers that come with the Mounting Block. Use a 4mm hex key to tighten the screws.
- Attach the Stylo HDCK Plate to the Back Support, using the M6 x 25mm bolt and washers provided in the fastener kit. Use a 4mm hex key to tighten the bolts.
- With the ball clamped in the Stylo 160 or Stylo 260 mechanism, insert the M4 x 10mm grub screws into the threaded hole opposite the clamp. Tighten against the ball to further lock the ball. Use a 2mm hex key to tighten the screws.
Spex Ltd
fasterresults@spexseating.com
32 Detroit Drive, Rolleston 7675, New Zealand
Call +643 307 9790 Fax +643 307 2820
www.spexseating.com
Manual: HDK20220302.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>