CyberView 1080p IP KVM Switch Installation Guide
- June 3, 2024
- CyberView
Table of Contents
CyberView 1080p IP KVM Switch
Please make sure to follow the below steps to setup your KVM IP properly
Configure the target server
The target server is the server that connected to the IP KVM Switch. Before use IP remote access, you need to turn off mouse acceleration of all target servers. Please refer to below for Windows operating system
Mouse setting
From the Control Panel, double-click the Mouse icon to open the Mouse Properties dialog box.
- Move the pointer speed slider to the default of 50%. ( the middle of the slider or the sixth tick from the left ).
- Uncheck “Enhance pointer precision”.
- Uncheck “Automatically move pointer to the default button in a dialog box” & “Display pointer trails”.
- Windows enables mouse acceleration by default. Make sure you are logged in to windows to check mouse synchronization.
- Mouse acceleration can only be turned off on a per Windows user basis. If you log in to Windows with a different user name, then you will have to configure mouse properties separately for that user as well
Change display scaling setting 100%
- Open Settings.
- Click on System.
- Click on Display.
- Under the “Scale and layout” section, select the scale 100%.
Logging in to IP KVM
The default IP address is as below:
- IP address : 192.168.1.22
- Subnet mask: 255.255.255.0
- Gateway : 192.168.1.1
IP KVM model with single IP port:
- Default address 192.168.1.22
IP KVM model with dual IP ports:
- The 1st IP address 192.168.1.22
- The 2nd IP address 192.168.1.23
To log in to the IP KVM do as follows:
- Open the browser on the client, in the address bar, enter the default IP KVM address ( 192.168.1.22 )
- In login dialog box, enter the user name and password, then click Login, the default user name is super and the default password is pass.
- The IP KVM GUI is displayed, and the navigation bar is on left-side.
Configure Remote Console Resolution
The IP remote console displayed on the HTML5-based browser support multiple
types of resolution, with a maximum of 1,920 x 1,200.
Click Remote Console and then Resolution, the Remote Console Video page is
displayed, select the same resolution as target servers, click Apply to save
the resolution
Launch remote console
Click Control and then Remote console, the Remote console Preview is
displayed, then Click Connect, the remoteconsole opens in a separate windows.
When first start, the local mouse is not synchronized with the remote mouse,
it appears at a distance to each other, press the Mouse Sync once (
positioning top left corner ), the mouse will align.
The company reserves the right to modify product specifications without prior
notice and assumes no responsibility for any error which may appear in this
publication. All brand names, logo and registered trademarks are properties of
their respective owners. Copyright 2022 Austin Hughes Electronics Ltd. All
rights reserved.
www.austin-hughes.com