PYLE PDWR30B Outdoor Waterproof Speaker System Instruction Manual
- June 13, 2024
- Pyle
Table of Contents
PYLE PDWR30B Outdoor Waterproof Speaker System
- Excellent for Use On Boats/ Marine/ Decks/ Patios/ Poolside/ Outdoors
- Completely Water Proof
- 3.5” Aluminum Injection Cone Woofer
- 40 Oz. Magnet Structure
- 1” High Compliance Myiar Tweeter
- Capacitor Crossover Network
- Bass Re ex Vent for Added Bass Response
- Heavy Duty ASB Construction
- Quick Connect/ Disconnect Speaker Terminals
- Unique Spring Loaded Mounting System
- Removable Rustproof Mesh Grills
- Power: 150Watts RMS/ 300Watts Peak
- Frequency Response: 60-20K Hz
- Impedance: 4 Ohms
- Dimensions: 4.75”(W)x 7.25”(H) x 4.75”(D
HOW TO INSTALL
MOUNTING THE BRACKET
- Remove the bracket knobs and the bracket from the speaker.
- Hold the bracket up to the mounting surface. “PDWR30B Waterproof Speakers” can be mounted either horizontally or vertically, holding the bracket so that the speaker wire.
- Through the large, circular wire hole in the bracket, align the bracket to be square with the surroundings (Use A level for accuracy)
- Mark the locations of the three shaped screw holes, use all of the holes
- Drill plot holes Into the mounting surface.
- Gently pull the speaker wire through the wire hole in the center of the mounting bracket, so that the holes all line up.
- Use your hardware to attach the bracket to the mounting surface.
FINAL ADJUSTMENTS
- After checking that the speaker is in phase and works correctly, angle the speaker for the best sound.
- Hand-tighten the bracket knobs only, power tools may over-tighten the knob, and strip the threads of the insert.
- Check that the entire installation is safe and secure.
CONNECTING YOUR SPEAKERS
Connecting the speakers to your amplifier or receiver.
Questions? Issues?
We are here to help!
Phone: (1) 718-535-1800
Email: support@pyleusa.com
- First, turn your amplifier OFF to avoid damage that may result from accidental shorting of the speaker leads.
- Correct phase polarity is critical for proper stereo imaging and bass performance.
- The red (+) terminal on your amplifier or The receiver must be connected to the red (+) terminal on your speaker, the same applies to the black (-) terminal.
- Connect one loudspeaker at a time to ensure proper connection of left and right channels. Make sure all wires are firmly fastened.
- If you notice a high level of bass or central image focus, double-check your connections for proper polarity.
Questions? Issues?
We are here to help!
Phone: (1) 718-535-1800
Email: support@pyleusa.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>