VISUAL COMFORT S 2320 Etoile Sconce User Guide
- June 3, 2024
- VISUAL COMFORT
Table of Contents
VISUAL COMFORT S 2320 Etoile Sconce User Guide
NOTICE
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect item and contents
carefully. If any damage or defect is found, do not install.
Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED)
- Phillips Screwdriver
- Slotted Screwdriver
- Drill
- Hammer
- Pencil
ASSEMBLY INSTRUCTIONS
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove mounting plate (A) from fixture body (C) by removing threaded caps (D)
-
Install mounting plate (A) to the junction box and secure with mounting screws (B)
-
Using fixture base (K) as a guide, line up with the wall and mark
anchor position. -
Using a drill bit slightly smaller than the anchor, drill hole in the
marked position. Install anchor (E) into the hole using the hammer. -
Insert the wood screw (F) to the anchor (E) and leave the
threads 1/8” out. -
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (I)
NOTE: It is imperative that the fixture is grounded. -
Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (I)
-
Connect fixture hot wire (black) to the supply hot wire (usually
black) using wire nut (I)
CAUTION: Do not reverse the hot and neutral connections. -
Make sure all wire connections are tight, then carefully tuck into the
junction box. -
Hook fixture base (K) to wood screw (F), then install fixture body (C) to mounting plate (A) and secure with threaded caps (C).
-
Remove socket ring (J) from socket (G), attach shade (H) to socket (G) and secure with socket ring (J ).
-
Install light bulb into the socket.
Care Instructions: Clean only with a soft dry cloth or feather duster.
Do not use abrasive or chemical agents
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>