TREND Lighting RDA8 Resi-LED 92mm 8W Led Downlight Instruction Manual
- June 3, 2024
- TREND Lighting
Table of Contents
INSTALLATION INSTRUCTIONS
Applicable for: RDA8, RDC8, RDT8, RDF8
RDA8 Resi-LED 92mm 8W Led Downlight
Model No| Input Voltage| Power (N)| Colour
Temperature| CRI| Ingress Protection
---|---|---|---|---|---
RDA83| 220-240| 8.5| 3000K| 90+| IP20
RDA84| 220-240| 8.5| 4000K| 90+| IP20
RDC83| 220-240| 8.5| 3000K| 90+| IP20
RDC84| 220-240| 8.5| 4000K| 90+| IP20
RDT83| 220-240| 8.5| 3000K| 90+| IP20
RDT84| 220-240| 8.5| 4000K| 90+| IP20
RDF83| 220-240| 8.5| 3000K| 90+| IP65
RDF84| 220-240| 8.5| 4000K| 90+| IP65
Step 1
Cut Out
RDA8: 76mm | RDC8: 92mm |
---|---|
RDT8: 78mm | RDF8: 76-92mm |
Please note: Ensure cut-out corresponds with selected fitting.
Step 2
Connect driver to 240v mains
Step 3
Bend springs upward and install luminaire into ceiling.
To maintain IP65 rating on RDF8 luminaires, ensure the luminaire is installed
on a flat, level ceilings and the silicone gasket has an adequate seal to the
mounting surface.
Installation Notes
IC-4 Rated
The Resiled range is IC-4 rated and can be installed in locations where it is
covered or abutted with thermally insulating material in accordance with
AS/NZS 60598.2.2:2016 ( IC-4 test ).
Important Safety Information
This product must be installed by a licenced electrician in accordance with
AS/NZS 3000 and local regulations.
To maintain IP65 protection on RDF8 luminaires, ensure the fitting is
installed in accordanc.e with the installation instructions and the mounting
surface is able to provide an adequate seal as per Step 3.
Approvals
The C-Tick marking of this product applies to AS/NZS CISPR15:2011 “Limits and methods of measurement of radio disturbance characteristics of electrical lighting and similar equipment.” This product is designed to conform to AS/NZS60598 “Luminaires, general requirements and tests”.
288 Coward Street Mascot NSW 2020
Ph: (02) 9669 8888 / Fax: (02) 9669 8899 / Email:
sales@trendlighting.com.au