SMART BOOSTER T5-A Cell Phone Signal Booster User Guide
- June 13, 2024
- SMART BOOSTER
Table of Contents
Cell Phone
Signal Booster
Quick Start Guide
T5-A
Package Contents
How It Works
If you do not have any
installation experience, please read the detailed installation guide within
the manual.
-
Find the outdoor area with Strongest Signal
-
Install the outdoor Antenna
-
Install the Booster PAY ATTENTION TO SELF-OSCILLATION*
-
Connect the System
-
Check the Coverage and Optimize
-
1)Walk around your house with your cell phone, search for the place where your phone gets the strongest signal reception, at least 3-4 signal bars.
2)Make a few phone calls there to check the call quality, if it is clear and stable, that will be an ideal position to place the outdoor antenna. -
Install the outdoor antenna on the wall near the location you found in Step 1. Make sure the antenna points towards the direction on where your cellular operator’s tower is.
To prevent lightening, the height of the outdoor antenna should be lower than the highest point of your house. -
Place the Booster at where strong signal is needed most.
*The Outdoor Antenna should be as far away as possible from the Indoor Antenna.
Minimum separation : 20 Feet Horizontal and 13 Feet Vertical. -
Connect the Outdoor Antenna cable with “BTS ” port on the cellular signal booster, and connect the Indoor Whip Antenna with “ANT” port on the booster. Then power on the booster and check the coverage.
-
1 It shows the outdoor signal strength your booster picked up from outside. The more bars you get, the better coverage the booster will produce. Try to get at least 2 bars, 3 bars will be the best.
2 The arrows represent the isolation between outdoor antenna and indoor antenna.
When flashing, it reminds you the separation between antennas are not enough. Try to increase more distance between antenna and make sure the antennas are not facing to each other.
Product Specifications
Model: T5-A
Network: AWS-1/Cellular/Low A-E Blocks/700 MHz Upper C Block/Broadband PCS
| Model No. | Smart Booster 55-A |
|---|---|
| Working Band | Low A-E Blocks |
AWS-1
UL Frequency
Range (MHz)| 699-716| 777-787| 824-849| 1850-1915| 1710-1755
DL Frquency Range (MHz)| 729-746| 746-756| 869-894| 1930-1995| 2110-2155
Maximum Gain| UL: 70±3 dB, DL: 70±3 dB
Maximum Output
Power| UL: 22±1 , DL: 10±1 dBm
AGC Range| ≥ 30dB
Ripple in Band| ≤ 7dB
Impedance| 50 ohm
Weight| Booster Device s2.0Kg
Whole Kit 55 kg
Dimension| 180 x 120 x 25 m
Power Supply| AC: 100-240 V, 50/60Hz, Output DC 5V/3.5A
Environmental
Condition| Booster: IP40
Antenna: IP65
- Usage of unauthorized antennas, cables, and/or coupling devices may result in poor effect and, insevere cases, equipment damage.
- a complete list of authorized antennas, cables, and/or coupling devices:
Name| Model| Gain/Loss| Photo
---|---|---|---
Indoor Whip Antenna(default)| /| 9dbi@698-2700MHz|
Outdoor Antenna(default)| IBG-9NJ-70/270-2| 10dbi@698-2700MHz| - the default antenna, cable, and/or coupling device that are shipped with the booster Log-periodic Antenna. Panel Antenna and CoaxialCable.
- The antenna is equipped with a U-shaped mounting bracket. The log-periodic antenna should be installed in a place with good outdoor signal. The panel antenna should be installed indoors and near the main device. If the amplification effect is not good after the installation is completed, the direction of the log-periodic antenna can be gradually adjusted to achieve better effect.
- The device has automatic Sleep function, strong anti-interference ability. over-power protection function, good heat dissipation design, and no radiation. The working noise is as low as GDB.
CPC-2-1-05 — Zone Enhancers – Spectrum management and telecommunications
http://www.ie.gc.ca/eielsite/smt-gst.nsyeng/st08r142.html 1
VVarntnwUnauthorizerl antennas/cables an or coupling devices are prohibited by
FCC rules. Please contact FCC for details: 1-888-CALL-FCC
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
This equipment should be installed and operated with a minumum distance of
20cm between the radiator and your body.
The antenna for the device must be installed to comply with the 10 meter above
ground maximum antenna height limitation
This equipment complies with IC radiation exposure limits set forth for an
uncontrolledenvironment. This equipment should be installed and operated with
minimum distance of 20 cmbetween the radiator and your body. This transmitter
must not be co-located or operating inconjunction with any other antenna or
transmitter.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subjectto the following two conditions:
- This device may not cause interference, and
- This device must accept any interference, including interference that may cause undesiredoperation of the device.
This is a CONSUMER device.
BEFORE USE, you must meet all requirements set out in CPC-2-1-05.
This device MUST ONLY be operated with approved antennas and cables as
specified by the manufacturer.
Antennas must be installed in a way where the minimum separation distance
between the antennas and a user (or bystander) specified by the manufacturer
is ALWAYS maintained.In order to reduce oscillations it is recommended that
sufficient separation distance is maintained between the donor and server
antennas of the zone enhancer system.You MUST cease operation of this device
immediately if requested by ISED or a licensed wireless service provider.
WARNING:E911 location information may not be provided or may be
inaccurate for calls served by using this device.
label:
Cellular Uplink: 824MHz – 849MHz, Downlink: 869MHz – 894MHz AWS-1 Uplink: 1710
– 1755MHz, Downlink: 2110 – 2155MHz Broadband PCS Uplink: 1850-1915MHz,
Downlink: 1930-1995MHz Low A-E Blocks: 699-716MHz, Downlink: 729-746MHz 700
MHz Upper C Block: 777-787MHz, Downlink: 746-756MHz
Product: Cell Phone Signal Booster
Model: 75-A
FCC ID: 2BB6MT5-A IC 31014-TSA
Made in China the antenna for the device must be installed to comply with the
10 meter above ground maximum antenna height limitation This is a CONSUMER
device.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have
your provider’s consent. Most wireless providers consent to the use of signal
boosters. Some providers may not consent to the use of this device on their
network. If you are unsure, contact your provider. In Canada, BEFORE USE you
must meet all requirements set out in ISED CPC-2-1-05. You MUST operate this
device with approved antennas and cables as specified by the manufacturer.
Antennas MUST be installed at least 20 cm (8 inches) from (i.e., MUST NOT be
installed within 20 cm of) any person. You MUST cease operating this device
immediately if requested by the FCC (or ISED in Canada) or a licensed wireless
service provider. WARNING. E911 location information may not be provided or
may be inaccurate for calls served by using this device. This device may be
operated ONLY in a fixed location (i.e., may operate in a fixed location only)
for in-building use
CPC-2- 1-05 — Zone Enhancers – Spectrum management and telecommunications
https://ised-isde.canada.ca/site/spectrum-management-telecommunications/en
/learn-more/keydocuments/procedures/client-procedures-circulars-cpc/cpc-2-1-05
-zone-enhancers
CEREVO TECHNOLOGY LIMITED
F22, Tower B, RuiChuangGuoJi Plaza, No.8 WangJing East Road, Chaoyang
District, Beijing, China 100102
Contact: Esson Diao
Tel: 18218747363
Email: 619991099@qq.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>