BLAZE PowerZone Connect Series Amplifier User Guide

BLAZE PowerZone Connect Series Amplifier

Download the Firmware update file

Visit blaze-audio.com/support to download the latest Firmware update for your amplifier.

Connect to the Amplifier via Wi-Fi

1. With the PowerZone Connect amplifier connected to a mains power supply, wait for the front panel Wi-Fi indicator to turn green.
2. Use a mobile, laptop or desktop device to search for available Wi-Fi networks. Connect to Blaze XXXXXXXXXXXXXXXX (serial nr.) using the password, “password” The amplifier’s serial number is located on its rear panel.
3. Open a web browser on your device and enter the IP address: 192.168.4.1
4. The PowerZone Control web app interface will now open
   • your gateway for updating the amplifier’s Firmware

Update the Firmware 1.3

1. You are now connected to the PowerZone Control web app
2. Go to Settings > Device > below Firmware update press “UPDATE”
3. Select the downloaded Firmware update file
4. Wait for installation to complete — the amplifier will restart itself in approx. 2 minutes
5. Reconnect to the amplifier’s Wi-Fi
6. Confirm successful update by refreshing the browser and checking the Firmware Version (Settings > Device)

Load a Speaker Preset from the Speaker Library

1. Download your Speaker Preset from blaze-audio.com/support
2. Connect to the amplifier and open the PowerZone Control web app
3. Go to Output > Speaker Presets > press Import Speaker Preset
4. Select the .zcp Speaker Preset file that you just downloaded
5. You are all set!

References

• Support - Blaze Audio

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>