Eibach RO-LIFT E30-82-008-01-20 Toyota FJ Cruiser Instruction Manual
- June 3, 2024
- Eibach
Table of Contents
Installation Instructions
PRO-LIFT # E30-82-008-01-20
Toyota FJ Cruiser
RO-LIFT E30-82-008-01-20 Toyota FJ Cruiser
Note: The Pro Truck Leveling Springs must not be used with the OE shocks.
Extended travel shocks are required to avoid damage to the suspension.
Note: Please refer to the instructions on the following page for proper
spring fitment when using the Eibach Pro Sport Truck Dampers
Kit Contents
| Description | Part Number | Qty |
|---|---|---|
| Front Spring | F31-82-008-01-FA | 2 |
| Information Kit | EPAK | 1 |
| Instructions | E30-82-008-01-20INST | 1 |
NOTES: Read All Instructions Before Beginning Installation
-
Only qualified mechanics experienced in the installation and removal of suspension components should perform this installation.
-
Use of a hoist is highly recommended and will substantially reduce installation time.
-
Never work on or under a vehicle unless it is properly supported by safety stands and wheels are blocked.
-
Never use impact wrenches or impact guns to install or remove shock absorber piston components, shafts and piston rod nuts.
-
PRO-LIFT springs should be installed with the Eibach Logo right side up. All original stock spring isolators, dampers and tubing should be retained from the stock springs and used when installing the PRO-LIFT Springs.
-
After installation, it is always important to inspect and adjust the following if necessary:
– Wheel alignment such as camber, caster & toe
– Tire and/or wheel fender clearance, when aftermarket tires and wheels are used.
– Brake line clearance and attachments
– Brake anti-locking and anti-skid system sensors -
Tire Rotation: In order to increase the life of your tires, it is recommended to rotate your tires every 3,000 miles.
-
For MacPherson Strut type front suspension, it is important to mark the orientation of the upper perch with respect to the lower perch before disassembly. This orientation must remain the same with the installation of the Pro Kit springs. Noise may result if this procedure is not performed correctly.
Additional Eibach Components Available For Your Truck
| Eibach Kits | Part Number | Description | Front | Rear |
|---|
Pro Truck Sport
Leveling front dampers| E60-82-008-02-10| Off-Road
Performance| +0-2.5”| N/A
Pro Truck Sport
Leveling rear dampers| E60-82-008-02-01| Off-Road
Performance| N/A| N/A
Spring Seat Fitting Instructions for Eibach Pro Sport Truck Dampers
Important: Ensure that the snap ring is fully seated in the snap ring
groove (you should be able to rotate the snap ring manually/by hand).
Note: Improper installation will cause permanent damage to the shock.
Please refer to the Pro Truck Sport Damper instructions for more info
regarding proper installation and fitment.
Notes:
The top three snap ring grooves are to be used to accommodate extra weight,
such as heavy duty bumper, winch, and other miscellaneous modifications that
may contribute to a lower overall ride height.
Use of the top three grooves to get more than 2.6” of lift may cause a
degradation of ride quality and may cause some clearance issues if the vehicle
has the stock upper
control arms.**
Average lift measurements shown are for Pro Truck Sport Dampers when used in
conjunction with Eibach Pro Lift Springs. The lift amounts are based on a
stock vehicle with no added aftermarket accessories or additional weight.
Eibach Springs, Inc.
264 Mariah Circle
Corona, California 92879-1751
USA
Tech Support 800-222-8811 Ext 114
www.eibach.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>