WINNERCOM ON PE NFC Touch Door Handle User Manual
- June 3, 2024
- Winnercom
Table of Contents
WINNERCOM ON PE NFC Touch Door Handle
Introduction
- Door handle Module (DHS)
- NFC & Capacitive Touch
- Pocket Light LED
- Hi-Speed CAN
The door handle module for Automotive has a NFC Reader and lock/Unlock 2ChannelCapacitive touch Sensor function. This module is installed inside of the door handle covers and will be attached to the outside door panel. This module is communicated with the CAN network which enables to connection to the car network to send the signal of the lock and unlock of the door and Pocket light LED On/Off control. It receives DC power from car battery at all time.
NFC DHS Design(BOM) & Application
CE -NFC Touch Door Handle
Attention
- Please always mount the Door handle Module before powering on the device to avoid circuit damage
- Before powering on the Module, check the power supply(Fig. 1)
- Module Input Power connects to the connector(Fig. 1)
Pin #.| Name| Description| In/Out| Wire Color| I/O
Level
---|---|---|---|---|---
1| V Bat(+Vcc)| Power Supply| Power| RED| Battery +
2| L_CAN(L)| CAN Low Signal| I/O| GREEN| 2.5±TBD V
3| TOUCH_1| LOCK| O| GRAY|
4| TOUCH_2| UNLOCK| O| PINK|
5| L_CAN(H)| CAN High Signal| I/O| BLUE| 2.5±TBD V
6| GND| Electric Ground| Power| BLACK| Gnd
Specifications
NFC Touch Data
Frequency Range| 13.56MHz for NFC
Operating Voltage| 9.0 ~ 16.0 [Vdc], Typical 12.0 [Vdc]
Current| Max 400mA @ Operation Mode
Operating Temp.| -30℃ ~ 75℃
Storage Temp.| -40℃ ~ 85℃
User Information and Instructions
FCC Part 15 Compliance information
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
FCC Caution
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Manufacturer information
| **** Manufacturer name | WINNERCOM Co., Ltd. |
|---|---|
| Address, City: | HUMAX Village, 216, Hwangsaeul-ro, Bundang-Gu, Seongnam-si, |
Gyeonggi-do, South KOREA 13595
Product name (type)| Vehicle active antenna & Touch door
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>