REINA A-ATA0835P Anita Polished Towel Rail Installation Guide

June 3, 2024
Reina

A-ATA0835P Anita Polished Towel Rail

ANITA INSTALLATION GUIDE

This product must be fitted only by a fully qualified installer.

DESCRIPTION DESCRIPTION ILLUSTRATION

RADIATOR x 1

|

Fixing choose the
appropriate fixing for the
wall material if required

|
PTFE tape|
Electric drill|

Masonry drill bit appropriate to the fixings

| drill bit

Adjustable spanner

|
RADIATOR BRACKETS x 4| WALL BRACKETS x 4|

Radiator valve hex key

|
FIXING BRACKETS x 4|

BRACKET COVER x 4

|

Flat head and philips head
screw drivers

|

END PLUG x 1

|

RAD. SCREWS x 4

|

WALL SCREWS x 4

|

1 lock shield valve and 1 gate or thermostatic valve

|
Spirit level| level
AIR VENT x 1| WALL ANCHORS x 4| FIXING SCREWS x 4| Measuring tape|

GENERAL RECOMMENDATION

– Before fitting the radiator it is necessary to wash out the heating system to remove any existing mud, scale, work residues, traces of flux, oil, etc.

– When the system water pH is outside the 5,5-8,5 range and/or when the dissolved is above 0,1mg/liter, it is always needed to protect the heating system components (the radiator is one of these) with a proper chemical treatment
compatible with all parts in contact with water (silicon rubber too).

– In order to fit the radiator to the wall, it is necessary to choose the proper fixings for the wall material.

– If the system water exceeds 50°C, please install a warning mark near the radiator to avoid any accidental scalding.

– Clean the radiator surface only with a soft cloth to avoid scratching the finish and do not use chemical agents during cleaning operations. It is prohibited to climb on the radiator.

– Maximum working temperature 95°C, maximum working pressure 4 bar.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals