Danfoss NovoCon M Digital Actuators User Guide
- June 3, 2024
- Danfoss
Table of Contents
Danfoss NovoCon M Digital Actuators User Guide
Operating Instructions
Safety Note
To avoid injury and damage to persons and devices, it is absolutely necessary
these instructions are carefully read and observed prior to assembly and
commissioning.
Necessary assembly, start-up, and maintenance work must be performed only by
qualified, trained and authorised personnel. Switch off the power line before
wiring the actuator.
If the NovoCon® M network is supplied with two or more AC power boosters, caution must be observed when disconnecting one of the transformers from the high voltage power line. As the NovoCons are connected in a daisy chain, there may be high voltage on the primary side of the disconnected power supply. Disconnect always both the primary and secondary side of the transformer.
Firmware update
We recommend to validate the firmware version before installation.
The latest firmware can be downloaded at
www.novocon.com by selecting the tab: Support files.
Part Name| Lead (Pb)| Mercury (Hg)| Cadmium (Cd)| Hazardous Su Hexavalent
Chromium (Cr(VI))| bstances Table Polybrominated biphenyls (PBB)|
Polybrominated diphenyl ethers (PBDE)
---|---|---|---|---|---|---
Motor| X| O| O| O| O| O
O: Indicates that this hazardous substance contained in all of the homogeneous
material for this part is below the limit requirement in GB/T 26572;
X: Indicates that this hazardous substance contained in at least one of the homogeneous material for this part is above the limit requirement in GB/T 26572;
Danfoss A/S
Climate Solutions • danfoss.com • +45 7488 2222
Any information, including, but not limited to information on selection of
product, its application or use, product design, weight, dimensions, capacity
or any other technical data in product manuals, catalogues descriptions,
advertisements, etc. and whether made available in writing, orally,
electronically, online or via download, shall be considered informative, and
is only binding if and to the extent, explicit reference is made in a
quotation or order confirmation. Danfoss cannot accept any responsibility for
possible errors in catalogues, brochures, videos and other material. Danfoss
reserves the right to alter its products without notice. This also applies to
products ordered but not delivered provided that such alterations can be made
without changes to form, fit or function of the product.
All trademarks in this material are property of Danfoss A/S or Danfoss group
companies. Danfoss and the Danfoss logo are trademarks of Danfoss A/S. All
rights reserved.
4 | © Danfoss | DCS-S/SI | 2021.09 73697030 / AQ291838446552en-010501
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>